Marvel Industries 61ARMBBOL Drill panel mounting holes, Mark and drill lock hole, Material Type

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS

the surrounding cabinetry. If your handle attaches from the back-side of the custom panel, locate the mounting holes while the panel is attached to the door and cabinet. After the panel is removed from the door, drill the mounting holes from the front, to the recommended diameter of the handle manufacturer. Counter bore the back-side of the panel so the screw heads do not interfere with the surface of the door.

Step 6: Drill panel mounting holes

Re-clamp the panel to the door per step 5 and drill the screw pilot holes for attaching the overlay panel to the door. Select the size of the hole from Table C. Be careful not to drill the pilot holes through the overlay panel, 1⁄2" (12.7mm) deep for 3⁄4" (19mm) and 5⁄8" (15.7mm) panels.

Material Type			#8 Wood Screw
Hardwood	1⁄8" (3.2mm) Diameter. Pilot Hole
Softwood	7⁄64 (2.8mm) Diameter. Pilot Hole
	Table C
		If	your refrigerator has a door
NOTE
		lock proceed to Step 7. If your
		refrigerator does not have a
		door lock proceed to Step 9.

Step 7: Mark and drill lock hole.

Locate and mark with a pencil the location of the lock hole on the overlay panel, this is the hole in the top corner of the handle side of the door. Remove the clamp and re- move the overlay panel from the door. On the backside of the panel where you marked the lock location drill a 13⁄16" (20.5mm) diameter counter bore 7⁄16" (11.0mm) deep into the overlay panel. Drill a 15⁄32" (12.0mm) diameter hole through the overlay panel centered on the counter bore be- ing careful not to splinter the wood on the face side of the panel. (See Figure 10).

Top Hinge

Adapter

Figure 8

Hole in hinge adapter

Door

Overlay Panel

Hole in bottom hinge adapter

1.234" (31.3mm)

.991" (25.2mm)

Figure 9

18