U-Line ICE-MAKER/REFRIGERATOR user manual Leveling the Unit, Grill Installation

Page 10

User’s Manual

8.Allow at least 1-1/2 inches clearance behind the unit for electri- cal and water supply connections.

LEVELING THE UNIT

It is important that the unit, primarily the ice maker assembly, is level. All 75 and 15 Series units are equipped with adjustable feet for level- ing and height adjustment (see Figure 9). All other units have rubber feet.

TURN FOOT TO ADJUST

UL105

Figure 9

GRILL INSTALLATION

NOTE

Model SP18 Icemakers come with the grill already installed.

1.With a standard blade screwdriver (or 1/4” nutdriver), remove the screw needed to attach the grill (see Figure 10).

2.Remove the control knob by pulling it toward you.

3.Carefully remove the grill from inside the unit. A small screw hole is located toward the top of the middle recessed section of the grill.

8

Image 10

Contents User’s Manual Line Corporation Limited Warranty Introduction Please Record Your MODEL’S InformationTable of Contents Safety PrecautionsPage Installation Site PreparationCabinet Or Wall Door Swing Clearance Needed Connecting the Water Supply UL002A UL100 Grill Installation Leveling the UnitGrill Screw Glass Shelf Installation For Models with Glass ShelvesReversing the Door Bushing Place door on lower hinge UL128 Clean out bush Ing hole in door bottom with Aligning the DoorCustom Door Panel Insert Installation Custom Door Panel DimensionsUL132 UL131 BUILT-IN Installation Unit Dimensions000 Initial START-UP OFFUL120 Normal Operation Adjusting the Temperature Control Adjusting ICE Cube Size Care and Cleaning Defrosting StorageTroubleshooting Before Calling for ServiceConnecting If Service is Required SpecificationsPage Box Milwaukee, WI Phone FAX