User’s Manual
12.Adjust door to assure proper seal. Tighten upper hinge screws securely.
13.Replace three plastic plugs removed in step 8 into holes on top of unit. Replace screws in holes in bottom of unit, opposite side.
14.Reinspect door seal and alignment. Adjust if needed.
15.Reinstall grill (1 screw).
NOTE
On Combo Models 75A and 75FF
To reverse the door mounting on Models 75AD, 75R, 75RF, Combo 75A, and Combo 75FF, perform the following:
1.Remove grill (1 screw). See Figure 13.
2.Remove top hinge from cabinet (4 screws). See Figure 14. Hold door to keep it from falling.
3.Lift the door off the bottom hinge.
4.Remove four plastic plugs in hinge holes, top of cabinet, opposite side (see Figure 20). Be careful not to scratch cabinet.
5.Remove pivot screw from top hinge, invert screw and rein-
stall pivot screw in top hinge. See Figure 19. Do not install hinge on cabinet at this time.
6.Remove bottom hinge from cabinet (4 screws) and
screws on opposite side of cabinet (see Figure 22).
7. Remove pivot screw from bottom hinge, invert screw and reinstall pivot screw in hinge (see Figure 19).
UL128
Figure 22
14 