U-Line ICE-MAKER/REFRIGERATOR user manual Place door on lower hinge

Page 15

8.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. See Figure 19.

	HINGE
RIGHT SIDE	LEFT SIDE
DOOR SWING	DOOR SWING

	SCREW
RIGHT SIDE	INVERT	INVERT
HINGE	SCREW	HINGE
		UL115

Figure 19

9.Remove three plastic plugs in hinge holes, top of cabinet, opposite side. Be careful not to scratch cabinet (see Figure 20).

11.Fasten upper hinge to unit (3 screws). Partially tighten screws until door is aligned. See Figure 21.

	UL114
	Figure 20
	10. Place door on lower hinge	UL119
	pin. Invert and install upper	UL119
	pin. Invert and install upper	Figure 21
	hinge on door.	Figure 21

13

Image 15

Contents User’s Manual Line Corporation Limited Warranty Please Record Your MODEL’S Information IntroductionSafety Precautions Table of ContentsPage Site Preparation InstallationCabinet Or Wall Door Swing Clearance Needed Connecting the Water Supply UL002A UL100 Leveling the Unit Grill InstallationGrill Screw For Models with Glass Shelves Glass Shelf InstallationReversing the Door Bushing Place door on lower hinge UL128 Aligning the Door Clean out bush Ing hole in door bottom withCustom Door Panel Dimensions Custom Door Panel Insert InstallationUL132 UL131 Unit Dimensions BUILT-IN Installation000 OFF Initial START-UPUL120 Normal Operation Adjusting the Temperature Control Adjusting ICE Cube Size Care and Cleaning Storage DefrostingBefore Calling for Service TroubleshootingConnecting Specifications If Service is RequiredPage Box Milwaukee, WI Phone FAX