U-Line ICE-MAKER/REFRIGERATOR user manual UL132 UL131

Page 19

Install the insert as follows:

!WARNING

Insert edges may be SHARP! Use care when installing.

1.Remove top hinge screw pin (large Phillips head, see Figure 25). Hold door to keep it from falling.

2.Remove door, being careful not to scratch top of door on hinge.

3.Remove two small screws holding door handle. Slightly separate door handle from door (see Figure 26).

UL132

	UL131
Figure 25	Figure 26

4.Pull door gasket out of groove (top edge of door only). Start in the middle and pull outwards, moving towards the edge (see Figure 27). This may take some force.

5.Pull handle up and off.

UL117

Figure 27

17

Image 19

Contents User’s Manual Line Corporation Limited Warranty Please Record Your MODEL’S Information IntroductionSafety Precautions Table of ContentsPage Site Preparation InstallationCabinet Or Wall Door Swing Clearance Needed Connecting the Water Supply UL002A UL100 Leveling the Unit Grill InstallationGrill Screw For Models with Glass Shelves Glass Shelf InstallationReversing the Door Bushing Place door on lower hinge UL128 Aligning the Door Clean out bush Ing hole in door bottom withCustom Door Panel Dimensions Custom Door Panel Insert InstallationUL132 UL131 Unit Dimensions BUILT-IN Installation000 OFF Initial START-UPUL120 Normal Operation Adjusting the Temperature Control Adjusting ICE Cube Size Care and Cleaning Storage DefrostingBefore Calling for Service TroubleshootingConnecting Specifications If Service is RequiredPage Box Milwaukee, WI Phone FAX