Smeg GKC641-3 manual Electrical Connection, Instructions for the installer, plate for any reason

Page 6
3. ELECTRICAL CONNECTION

Instructions for the installer

3. ELECTRICAL CONNECTION

Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this

plate for any reason.

The plug on the end of the supply cable and the wall socket must be the same type and conform to the current electrical system regulations. Check that the power line is adequately grounded.

On the power line, install an omnipolar cut-off device with contact cut-off distance greater than or equal to 3 mm, located in an easily accessible position near the unit.

Do not use reducers, adapters or shunts.

If the power cable is replaced, the wire section on the new cable must not be less than 1.5 mm2 (3 x 1.5 cable), keeping in mind that the end to be connected to the hob must have the ground wire (yellow-green) longer by at least 20 mm. Use only H05V2V2-F cable or similar which has a maximum temperature of 90°C. Any replacement needed should be carried out by a specialised technician who should make the mains connections according to the following diagram.

L = brown N = blue

plate for any reason.= yellow-green

The manufacturer will not be liable for any damage to persons or property caused by non-observance of the above instructions or deriving from the tampering of even a single part of the hob.

26

Image 6
Contents Index THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE Introduction1. INSTRUCTIONS FOR SAFE AND PROPER USE NEVER UNPLUG BY PULLING ON THE CABLETHE PLATE ON THE CASING MUST NOT BE REMOVED Instructions for the installer 2. POSITIONING OF HOB2.1.1 Attachment to support structure Instructions for the installer 3. ELECTRICAL CONNECTION plate for any reason4. GAS CONNECTION 4.1 Connection to LPG 4.2 Ventilation of rooms4.3 Discharge of combustion products 5. ADAPTATION TO DIFFERENT TYPES OF GAS 5.1 Removing the hobRated heating capacity kW 5.2 Regulation for LPGBurner LPG - G30/G31 28/37 mbar5.3 Regulation for natural gas 5.4 Regulation of primary air6. FINAL OPERATIONS 6.1 Regulation of minimum for natural gas6.2 Regulation of minimum for LPG This must be done by a qualified technician 6.3 Arrangement of burners on hob6.4 Lubrication of gas taps BURNERS7. USING THE HOB Instructions for the user7.1 Ignition of the burners 7.4 Electric elements 7.2 Practical advice for using the burners7.3 Diameter of containers Burner7.4.2 Using the electric elements 8.2 Cleaning of cooking hob components 8. CLEANING AND MAINTENANCE8.1 Cleaning Before any intervention, disconnect the power supply of the device8.2.2 The cover