Smeg GKC641-3 manual Final Operations, Regulation of minimum for natural gas

Page 12
6. FINAL OPERATIONS

Instructions for the installer

6. FINAL OPERATIONS

Having carried out the above adjustments, reassemble the appliance following, backwards, the instructions in paragraph “5.1 Removing the hob”.

6.1Regulation of minimum for natural gas

Replace the components on the burner and slide the knobs on the gas tap pins.

Light the burner and set it at minimum position. Remove the knob and turn the regulation screw inside or next to the gas tap pin (depending on

the model) until you get a suitable minimum flame.

Replace the knob and check burner flame stability: (rapidly turning the knob from maximum to minimum position, the flame should not go out).

6.2 Regulation of minimum for LPG

To regulate the minimum for LPG, completely tighten (clockwise) the screw inside or next to the gas tap pin (depending on the model).

The diameters of the by-passes for each burner are given in table “5.2 Regulation for LPG”.

After having regulated the device with gas other than the one tested, replace the label located on the guard with the one that corresponds to the new gas. The label is inside the bag that contains the nozzles provided.

32

Image 12
Contents Index Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USETHE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE NEVER UNPLUG BY PULLING ON THE CABLETHE PLATE ON THE CASING MUST NOT BE REMOVED Instructions for the installer 2. POSITIONING OF HOB2.1.1 Attachment to support structure Instructions for the installer 3. ELECTRICAL CONNECTION plate for any reason4. GAS CONNECTION 4.1 Connection to LPG 4.2 Ventilation of rooms4.3 Discharge of combustion products 5. ADAPTATION TO DIFFERENT TYPES OF GAS 5.1 Removing the hob5.2 Regulation for LPG BurnerRated heating capacity kW LPG - G30/G31 28/37 mbar5.3 Regulation for natural gas 5.4 Regulation of primary air6. FINAL OPERATIONS 6.1 Regulation of minimum for natural gas6.2 Regulation of minimum for LPG 6.3 Arrangement of burners on hob 6.4 Lubrication of gas tapsThis must be done by a qualified technician BURNERS7. USING THE HOB Instructions for the user7.1 Ignition of the burners 7.2 Practical advice for using the burners 7.3 Diameter of containers7.4 Electric elements Burner7.4.2 Using the electric elements 8. CLEANING AND MAINTENANCE 8.1 Cleaning8.2 Cleaning of cooking hob components Before any intervention, disconnect the power supply of the device8.2.2 The cover