Smeg XXSC111P Pyrolysis automatic oven cleaning, Before starting the automatic cleaning cycle

Page 24

Instructions for the User

11.6 Pyrolysis: automatic oven cleaning

Pyrolysis is an automatic high-temperature cleaning procedure which causes dirt to dissolve.

Before starting the automatic cleaning cycle, make sure that the oven does not contain any foods or large spills from previous cooking operations inside.

During the pyrolysis cycle adoor interlock device makes it impossible to open the door.

IF THE OVEN IS INSTALLED UNDERNEATH A HOB, MAKE SURE THAT THE BURNERS OR ELECTRIC PLATES REMAIN OFF DURING THE AUTOMATIC CLEANING CYCLE.

11.6.1 Before starting the automatic cleaning cycle

Pyrolysis may be carried out at any time of the day or night (if you wish to benefit from the lower cost of electricity overnight).

Before proceeding, check the following:

•only the confectionery tray, the oven tray and the roof liner may be left inside the oven since they will withstand the high temperatures of the pyrolysis process; all the other accessories must be removed from inside the oven.

•make sure that the oven door is firmly closed.

When setting the cleaning cycle duration, refer to the chart below:

CLEANING

LIGHT DIRT

MEDIUM DIRT

HEAVY DIRT

DURATION

90 MIN.

135 MIN.

180 MIN.

During the first automatic cleaning cycle unpleasant smells may occur due to the normal evaporation of oily manufacturing substances. This is an absolutely normal phenomenon which disappears after the first cleaning cycle.

During the automatic cleaning cycle the fans make more noise because they are running at higher speed. This is an absolutely normal function, intended to provide more effective heat dispersal. At the end of the pyrolysis process the fans continue to run automatically for long enough to prevent overheating of the sides of the cabinet and the front of the oven.

58

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Table of Contents Precautions for Use Precautions for USEDisposal instructions Disposal Instructions OUR Environment PolicySafety precautions Safety PrecautionsBefore Installation Instructions for the UserGET to Know Your Oven Description of Front Panel Controls For convenience it will be referred to as PT1From now on, for convenience it will be referred to as DSP1 From now on, for convenience it will be referred to as DSP2FUNCTION-SWITCH on Knob From now on, for convenience it will be referred to as PT2Using the Oven Precautions and General AdviceOperating modes First use Selecting the functionProgrammed cooking procedures Timed cooking with timerModifying the data set Semiautomatic cookingAutomatic cooking Secondary menu Child safety lock-out function Power selection functionShow Room Function Cooling fan system Inside lightUsing the Pizza Function on Some Models only Precautions for using the pizza plateTo save energy Accessories Available Chromium-plated gripper useful forRecommended Cooking Tables Conventional CookingGrilling Rotisserie Cooking on Some Models only Cleaning and Maintenance Cleaning stainless steelRoutine daily cleaning Food stains or spillsCleaning the oven On some models onlyCleaning the door glazing Pyrolysis automatic oven cleaning Before starting the automatic cleaning cycle90 MIN 135 MIN 180 MIN How the automatic cleaning cycle works 300500 Setting the cleaning cycle Extraordinary Maintenance Changing the light bulbInstructions for the Installer Removing doors with pinsRemoving the door Removing the gasketRemoving the inside glass with the door cold Installing the Appliance Electrical connectionOperation at 220-240 V~ use a Positioning the oven Instructions for the Installer
Top Page Image Contents