Smeg XXSC111P Installing the Appliance, Electrical connection, Operation at 220-240 V~ use a

Page 30

Instructions for the Installer

13.INSTALLING THE APPLIANCE

13.1Electrical connection:

The nameplate with the technical data, serial number and mark is in a visible position on the oven door surround.

The nameplate must never be removed.

The appliance must be connected to earth in compliance with electrical system safety regulations.

If a permanent connection is used, the appliance's power supply line must be fitted with an omnipolar breaking device with contact gap of at least 3 mm, located in an easily accessible position close to the appliance itself.

If a socket and plug connection is used, check that they are of the same type. Do not use reducers, adapters or junctions since they may cause overheating or burns.

Operation at 220-240 V~: use a

type H05RR-F (3 x 1.5 mm2) or

type H05V2V2-F (3 x 1.5 mm2) three-wire cable.

The earth wire (yellow-green) must be at least 20 mm longer than the other wires at the end for connection to the appliance.

If the power supply lead has to be replaced, remove the rear casing by undoing the screws as shown below. Tpower lead gauge must be at least

1.5mm2 (3 X 1.5 cable) and it must withstand temperatures up to 90°C (H05V2V2-F). Make sure that the cables follow the best possible route and use band clamps to fix them at the side of the cabinet, to avoid any contact with the oven.

64

Image 30

Contents Table of Contents Precautions for Use Precautions for USEDisposal instructions Disposal Instructions OUR Environment PolicySafety precautions Safety PrecautionsBefore Installation Instructions for the UserGET to Know Your Oven From now on, for convenience it will be referred to as DSP1 Description of Front Panel ControlsFor convenience it will be referred to as PT1 From now on, for convenience it will be referred to as DSP2FUNCTION-SWITCH on Knob From now on, for convenience it will be referred to as PT2Using the Oven Precautions and General AdviceOperating modes First use Selecting the functionModifying the data set Programmed cooking proceduresTimed cooking with timer Semiautomatic cookingAutomatic cooking Secondary menu Child safety lock-out function Power selection functionShow Room Function Cooling fan system Inside lightUsing the Pizza Function on Some Models only Precautions for using the pizza plateTo save energy Accessories Available Chromium-plated gripper useful forRecommended Cooking Tables Conventional CookingGrilling Rotisserie Cooking on Some Models only Routine daily cleaning Cleaning and MaintenanceCleaning stainless steel Food stains or spillsCleaning the oven On some models onlyCleaning the door glazing Pyrolysis automatic oven cleaning Before starting the automatic cleaning cycle90 MIN 135 MIN 180 MIN How the automatic cleaning cycle works 300500 Setting the cleaning cycle Extraordinary Maintenance Changing the light bulbRemoving the door Instructions for the InstallerRemoving doors with pins Removing the gasketRemoving the inside glass with the door cold Installing the Appliance Electrical connectionOperation at 220-240 V~ use a Positioning the oven Instructions for the Installer