Reflector-to-Mount Assembly
Using a Crane
Step 1
Step 2
The reflector can be installed on the mount manually or by using a crane. However, Andrew recommends that this procedure be performed using a crane.
The following steps provide the procedure for installing the reflector to the mount using a crane.
Route a sling through the upper holes in the reflector torsion box assembly, and connect the ends using a 5/8 inch shackle as shown in Figure
NOTE: If using a steel sling, install foam pad protection in the upper reflector torsion box holes under the sling to avoid disfiguration of the reflector.
Figure 3-42: Sling Placement
Route two rope tag lines through two consecutive holes in the torsion box assembly to be used as guides when the reflector is lifted with a crane.
Figure 3-43: Safety Rope Tag Lines
55 | Installation Procedures |