Whirlpool W10196160B Replace Oven Racks Storage or Warming Drawer, Complete Installation

Check Operation of Oven Broil Burner

1.Close the oven door.

2.Press the BROIL pad.

3.Press the START pad.

The oven burner should light within 8 seconds. Under certain conditions it may take the burner up to 50 to 60 seconds to light.

Refer to the Use and Care Guide for proper operation of the oven controls.

Adjust Oven Broil Burner Flame (if needed)

Look through oven window to check broil burner for proper flame. This flame should have a ½" (1.3 cm) long inner cone of bluish-green, with an outer mantle of dark blue, and should be clean and soft in character. No yellow tips, blowing or lifting of flame should be present.

If flame needs to be adjusted:

1.Loosen the lock screw on the air shutter located at the rear of the broil burner.

2.Adjust the air shutter as needed.

3.Tighten lock screw.

A

B

A. Lock screw

4.Press CANCEL/OFF when finished.

Replace Oven Racks and

Storage or Warming Drawer

Replace oven racks in oven cavity. Replace storage or warming drawer.

To Replace Storage Drawer:

1.Insert storage drawer or warming drawer into slide rails on sides of drawer opening.

2.Lift front of drawer slightly and push firmly to close drawer.

Complete Installation

1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

2.Check that you have all of your tools.

3.Dispose of/recycle all packaging materials.

4.Check that the range is level. See “Level Range.”

5.Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, see the “Range Care” section of the Use and Care Guide.

6.Read the Use and Care Guide.

7.Turn on surface burners and oven. See the Use and Care Guide for specific instruction on range operation.

If range does not operate, check the following:

■Household fuse is intact and tight, or circuit breaker has not tripped.

■Range is plugged into a grounded 3 prong outlet.

■Electrical supply is connected.

■See “Troubleshooting” in the Use and Care Guide.

8.When the range has been on for 5 minutes, check for heat. If the range is cold, turn off the range and check that the gas supply line shutoff valve is open.

■If the gas supply line shutoff valve is closed, open it, then repeat the 5-minute test as outlined above.

■If the gas supply line shutoff valve is open, press the CANCEL button on the oven control panel and contact a qualified technician.

If you need Assistance or Service:

Please reference the “Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your range.

11