Complete Installation
1.Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply.
2.Refer to the “Electronic Ignition System” section for proper burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.
Checking for proper cooktop, bake and broil burner flame is very important. The small inner cone should have a very distinct blue flame ¼" (0.64 cm) to ½" (1.3 cm) long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip.
3.Refer to “Complete Installation” in the “Installation Instructions” section of this manual to complete this procedure.
Natural Gas Conversion
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect
Reconnect the
Failure to follow these instructions can result in death or serious burns to children and adults.
1.Turn the manual shutoff valve to the closed position.
2.Unplug range or disconnect power.
B
A
C
A. To range
B. Manual shutoff valve “closed” position
C. Gas supply line
3.Remove plastic cover from gas pressure regulator cap.
4.Turn gas pressure regulator cap counterclockwise with a ⁵⁄₈" combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
F
Side view before
A |
|
|
|
|
|
| LP |
B F | D | E | LP |
|
|
NG
C | Side view after | NG |
| ||
|
|
A. Plastic cover
B. Gas pressure regulator cap with hollow end facing out C. Gas pressure regulator cap with solid end facing out D. Washer
E. Gas pressure regulator cap
F. Gas regulator shutoff valve (shown in the “open” position
5.Turn over the gas pressure regulator cap and reinstall on regulator so that the solid end faces out and the marking “<- N” is facing the direction shown in the above drawing.
To Convert Gas Pressure Regulator
1.Remove storage drawer or warming drawer. See “Replace Oven Racks and Storage or Warming Drawer” section.
2.Locate gas pressure regulator at rear of storage or warming drawer compartment.
NOTE: On models with a warming drawer, an access cover must be removed from the gas pressure regulator.
A
6.Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners
1.Remove burner cap.
2.Using a Phillips or Quadrex® screwdriver, remove the burner base.
NOTE: Reinstall one of the screws through the range cooktop to hold the orifice spud holder in place while removing and replacing the orifice spuds.
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
14