Takes about 30 seconds. The, Door lock

–Press the – or + key to change the duration of the pyrolysis. You can choose between the following times: 02:00, 02:30 and 3:00.

–Press the (Confirm) key to start pyrolysis. An audible signal is sounded.

–For your safety, the oven door is locked immediately. The locking and unlocking process

takes about 30 seconds. The		(door lock)
symbol lights up during this time. The oven
lighting goes off. On the display, the			(door
lock),	(cooking time) and	(pyrolysis)


symbols light up.

Do not try to open the oven door during the self- cleaning process.

Note: during the pyrolysis process, it is not possible to query the temperature value nor the time.

End of pyrolysis:

After the pyrolysis process has ended, an audible signal sounds and the (cooking time) symbol flashes. Press any key and turn the “Temperature" control knob to the 0 position and the “Mode" knob to a position other than Pyrolysis.

Please note that, for safety reasons, the door will not be unlocked until until the oven has cooled down to 150 °C. The door lock symbol goes off.

Wait until the oven has cooled down; then, you can remove any pyrolysis residues (e.g. ash) from the oven compartment.

In this mode of operation (auto pyrolysis), even stubborn soiling is burnt away at temperatures around 485 °C.

After the pyrolytic cleaning process, you can remove the ash easily from the oven using a moist cloth.

Ending the pyrolysis process before expiry of the entered time:

–Turn the “Temperature" control knob to the 0 position and the “Mode" control knob to a position other than Pyrolysis.

–Pay attention to the fact that the door is not unlocked until at a temperature of 150 °C or less.

Tip: wait until the appliance indicates that the pyrolysis process has ended. This ensures that you will achieve an optimum cleaning result.

Starting pyrolysis at a later time:

–Enter the required switch-off time (see Chapter 3).

–Turn the control knobs to the pyrolysis setting as described above.

Note: you can query the current pyrolysis time by pressing the (Timer) key. You can increase the length of the pyrolytic cleaning process during operation. Press the + key to increase the value by 30 minutes in each case. Confirm the value by pressing the (confirmation) key.