Aiwa NSX-A111 manual Press on deck 1 to start recording on the first side

A OPEN/CLOSE		3,7
		)
	.... ..
4	.~-—.	4
	~:: _:~-	5
		3,7

1,8
6,8	‘..._ /./,
	u

The Al edit recording function enables CD recording without worrying about tape length and track length. When a CD is inserted, the unit automatically calculates the total track length. If necessary, the order of tracks is rearranged so that no track is cut short,

(Al: Artificial Intelligence)

1 Insert the tape to be recorded on into deck 1, and wind up to the beginning of the front side.

Press W4 to open the cassette holder and insert the tape

with the exposed side down. Wind up the tape with *.

2Press CD and load the disc(s).

3Press C!3 EDIT/CHECK once while pressing

SHIFT on the remote control.

“EDIT” is displayed.

EDIT

●When ‘(PRGM” is displayed, press CD EDIT/CHECK while pressing SHIFT again.

4 Press DISC DIRECT PLAY 1-3 to select a disc.

5 Press numbered buttons O-9 on the remote control to designate the tape length.

10 to 99 minutes can be specified.

Example: When using a 60-minute tape, press 6 and O.

In a few seconds, the tracks to be recorded on each side of the tape are determined.

●- and - are also available to designate the tape length.

Remaining time	Programmed
of recording	tracks for side A

I

Tape l~ngth Tape side L Minus mark

A:First recording side

B:Second recording side

6 Press ● on deck 1 to start recording on the first side.

CD play and recording of edited tracks for the first side start simultaneously. When the end of the tape is reached, deck 1 enters the recording stop mode. After entering the recording stop mode, go to step 7.

7 Press CD EDIT/CHECK while pressing SHIFT on the remote control to display the program for the second recording.

“B”is displayed.

8Turn over the tape in deck 1 and press ● to start recording on the second side.

To stop recording

Press ■/4 on deck 1. Recording and CD play stop

simultaneously.

To clear the edit program

Press ■ CLEAR for CD twice in stop mode so that “EDIV disappears on the display or = OPEN/CLOSE for CD,

To check the order of the programmed track numbers

Before recording, press CD EDIT/CHECK while pressing SHIFT

on the remote control to select side A or B, and press - or

*repeatedly.

Tape side Track number

Programmed track numbers

To add tracks from other discs to the edit program

If there is any time remaining on the tape after step 5, you can add tracks from other discs in the CD compartment

1 Press CD EDIT/CHECK while pressing SHIFT on the remote control to select side A or B.

2Press DISC DIRECT PLAY 1-3 to select a disc.

3Press numbered buttons on the remote control to select tracks. A track whose playing time is longer than the remaining time cannot be programmed.

4Repeat steps 2 and 3 to add more tracks,

Time on cassette tapes and editing time

The actual cassette recording time is usually a little longer than the specified recording time printed on the label. This unit can program tracks to use the extra time. When the total recording time is a little longer than the tape’s specified recording time after editing, the display shows the extra time (without a minus mark), instead of the time remaining on the tape (with the minus mark).

The Al edit recording function cannot be used with discs containing 31 tracks or more. “TROVER” is displayed if this is attempted,

12 ENGLISH