The clock is displayed. (The “:”between the hours and minutes flashes.) When the power cord is plugged into an AC outlet for the first time after purchase or when the clock setting is canceled due to a power failure, the entire clock display flashes.
1 Press CLOCK while pressing SHIFT,
2 Within 4 seconds, press - or
Pressing either button changes both the hour and the minute, Holding it down will vary the time rapidly by
3 Press Il.
The clock starts from 00 seconds.
To restore an original clock setting
Press CLOCK while pressing SHIFT on the remote control before completing step 3 to restore the previous time setting. This cancels any new setting.
To view the clock when another display is in the display
Press CLOCK while pressing SHIFT on the remote control. The time is displayed for 4 seconds and then the original display reappears, However, the clock cannot be displayed during recording.
To switch to the 24-hour standard
Press CLOCK while pressing SHIFT on the remote control and then press ❑ within 4 seconds.
Repeat the same procedure to restore the
If the display flashes when the clock is displayed, it indicates that the clock has stopped due to a power failure or the removal
~of the power cord. The current time needs to be reset.
2—
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press SLEEP while pressing SHIFT.
2 Within 4 seconds, press 4 or ~ to specify the time until the power is turned off.
The time changes between 5 and 240 minutes in
Specifi~d time
While the timer is in operation, the display indication is dimmer than usual.
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that “SLEEP oFF
appears on the display.