Aiwa Z-VR55 manual Explanation Graphical Symbols, Electric Power, Owner’s record, Installation

AR!!!!!SA

“CAUTION:TO REDUCE THE RISK OF

ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.”

4Ventilation — The unit should be situated with adequate space around it so that proper heat ventilation is assured, Allow 10 cm clearance from the rear and the top of the unit, and 5 cm from each side.

-Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings,

-Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded.

5Objects and liquid entry — Take care that objects or liquid do not get inside the unit through the ventilation openings.

6Carts and stands — When placed or mounted on a stand or cart, the unit

should be moved with care,		●L
Quick stops, excessive force, and uneven
surfaces	may cause the unit or cart to	m AL* 1
overturn	or fall.

7 Condensation — Moisture may form on the CD pickup lens

when:

-The unit is moved from a cold spot to a warm spot

-The heating system has just been turned on

-The unit is used in a very humid room

-The unit is cooled by an air conditioner

When this unit has condensation inside, it may not function

Explanation

A

A●

of Graphical Symbols:

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons,

The exclamation point within an equilateral triangle is intended to alert the user to the

presence of important operating and

maintenance (servicing) instructions in the literature accompanying the appliance.

normally. Should this occur, leave the unit for a few hours,

then try to operate again,

8 Wall or ceiling mounting —The unit should not be mounted

on a wall or-ceiling, u;less specified in the Operating

Instructions,

Electric Power

1 Power sources — Connect this unit only to power sources

specified in the Operating Instructions, and as marked on the

unit.

2 Polarization — As a safety feature, some units are equipped

with polarized AC power plugs which can only be inserted

one way into a power outlet. If it is difficult or impossible to

insert the AC power plug into an outlet, turn the plug over and

Owner’s record

For your convenience, record the model number and serial number (you will find them on the rear of your unit) in the space provided below. Please refer to them when you contact yourAiwa dealer in case of difficulty.

/ SX-R276 I 1

Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference, All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below.

Installation

1Water and moisture — Do not use this unit near water, such as near a bath, sink, swimming pool, or the like.

2Heat — Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat, It also should not be placed in temperatures less than 5°C

(41“F)or greater than 35°C (95”F).

3 Mounting surface — Place the unit on a flat, even surface.

try again. If it is not still inserted easily into the outlet, please

call a qualified service technician to service or replace the outlet, To avoid defeating the safety feature of the polarized plug, do not force it into a power outlet.

3AC power cord

-When disconnecting the AC power cord, pull it out by the AC power plug. Do not pull the cord itself,

-Never handle the AC power plug with wet hands, as this could result in fire or shock.

-Power cords should be firmly secured to avoid being severely

bent, pinched, or walked upon. Pay particular attention to the cord from the unit to the power socket.

-Avoid overloading AC power plugs and extension cords beyond their capacity, as this could result in fire or shock.

4Extension cord —To help prevent electric shock, do not use a polarized AC power plug with an extension cord, receptacle, or other outlet unless the polarized plug can be completely inserted to prevent exposure of the blades of the plug,

5When not in use — Unplug the AC power cord from the AC power plug if the unit will not be used for several months or more. When the cord is plugged in, a small amount of current continues to flow to the unit, even when the power is turned off

Outdoor Antenna

1Power lines — When connecting an outdoor antenna, make sure it is located away from power lines,

2Outdoor antenna grounding — Be sure the antenna system is properly grounded to provide protection against unexpected voltage surges or static electricity build-up. Article 810 of the National Electrical Code, ANS1/NFPA70, provides information on proper grounding of the mast, supporting structure, and the lead-in wire to the antenna discharge unit, as well as the size of the grounding unit, connection to grounding terminals, and requirements for grounding terminals themselves.

1ENGLISH