Aiwa Z-VR55 manual Insert the tape into Deck, Press CD and load the discs Press EDIT/CHECK m

The Al edit recording function enables CD recording without worrying about tape length and track length. When a CD is inserted, the unit automatically calculates the total track length. If necessary, the order of tracks is rearranged so that no track is cut short.

(Al: Artificial Intelligence)

1 Insert the tape into Deck 1.

Insert the tape with the side to be recorded on first facing out from the unit, and wind up the tape with -.

2Press CD and load the disc(s).

3Press EDIT/CHECK m.

“EDl~ and “Al”are displayed.

EDIT

●When ‘rPRGM” is displayed, press EDIT/CHECK again.

4 Press DIRECT, then press one of the numbered buttons 1 to 5 within 3 seconds to select a disc.

5 Press numbered buttons O-9 on the remote control to designate the tape length.

10 to 99 minutes can be specified.

Example: When using a 60-minute tape, press 6 and O.

In a few seconds, the tracks to be recorded on each side of the tape are determined. ”

●<, * or MULTI JOG are also available to designate the tape length.

	Remaining time	Programmed
Tape length	of recording	tracks for side A

I

Tape side

A: First recording side

B: -Second recording side

6Press ● on Deck 1 to start recording on the first side.

~flashes for 10 seconds, and then CD play and recording of edited tracks for the first side start simultaneously. When the end of the tape is reached, Deck 1 enters the recording stop mode. After entering the recording stop mode go to step 7.

7 Press EDIT/CHECK to display the program for the second recording.

“B”is displayed.

8Turn over the tape in Deck 1 and press ● to start recording on the second side.

To stop recording

Press ■/A on Deck 1.

Recording and CD play stop simultaneously.

To clear the edit program

Press ■CLEAR twice in the stop mode so that “EDIT”disappears on the display, or press AOPEN/CLOSE.

To check the order of the programmed track numbers Before recording, press EDIT/CHECK on the remote control to

select side A or B, and press - or * repeatedly.

Tape side Programmed track numbers

I	Program number
Track number

To add tracks from other discs to the edit program

If there is any time remaining on the tape after step 5, you can add tracks from other discs in the CD compartment.

1Press EDIT/CHECK on the remote control to select side A or B.

2Press DIRECT, then press one of the numbered buttons 1 to 5 within 3 seconds to select a disc.

3Press numbered buttons on the remote control to select the tracks.

A track whose playing time is longer than the remaining time cannot be programmed.

4Repeat steps 2 and 3 to add more tracks.

Time on cassette tapes and editing time

The actual cassette recording time is u&ally a little longer than the specified recording time printed on the label. This unit can program tracks to use the extra time. When the total recording time is a little longer than the tape’s specified recording time after editing; the display shows the extra time (without a minus mark), instead of the time remaining on the tape (with the minus mark).

m

The Al edit recording function cannot be used with discs containing 31 tracks or more.

13 ENGLISH