Aiwa Z-VR55 To clean the’ cabinet, There is no sound, Sound is emitted from one speaker only

Page 22

Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit.

To clean the’ cabinet

Use a soft and dry cloth.

If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents, such as alcohol, benzine or thinner as these could damage the finish of the unit.

To clean the heads and tape paths

After every 10 hours of use, clean the heads and tape paths with a head cleaning cassette or cotton swab moistened with cleaning fluid or denatured alcohol. (These cleaning kits are commercially available.)

When cleaning with a cotton swab, wipe the recording/playback head, erasure head (Deck 1 only), capstans, and pinchrollers.

Pinchroller’

1.I/

L

I

1

After cleaning the heads and tape paths with a liquid head cleaning cassette or a moistened swab, wait until the. cleaned parts are completely dry before inserting the tapes.

To demagnetize the heads

The heads may become magnetized after long-term use. This may narrow the output range of recorded tapes and increase noise. After 20 to 30 hours use, demagnetize the heads with any commercially available demagnetizer.

Care of discs

●When a disc becomes dirty, wipe the disc from the center out

●After playing a disc, store the disc in’ its case. Do not leave the disc in places that are hot or humid.

Care of tapes

●Store tapes in their cases after use.

●Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise.

●Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.

If the unit fails to perform as described in these Operating Instructions, check the following guide.

GENERAL

There is no sound.

●Is the AC cord connected properly?

●Is there a bad connection? (+ page 4)

●There may be a short circuit in the speaker terminals.

+Disconnect the AC cord, then correct the speaker connections.

●Was an incorrect function button pressed?

Sound is emitted from one speaker only.

●Is the other speaker disconnected?

An erroneous display or a malfunction occurs.

+Reset the unit as stated below.

TUNER SECTION

There is constant, wave-like static.

●Is the antenna connected properly? (+ page 4)

●Is the signal weak?

- Connect an outdoor antenna.

The reception contains noise interferences or the sound is distorted.

●Is the system picking up external noise or multipath distortion? -+ Change the orientation of the antenna.

- Move the unit away from other electrical appliances.

CASSETTE DECK SECTION

The tape does not run.

●Is the deck in pause mode? (+ page 9)

The sound is off-balance or not adequately high.

●is the playback head dirty? (+ page 21)

Recording is not possible.

●Is the erasure prevention tab on the tape broken off? (+ page 12)

●Is the recording head dirty? (+ page 21)

Erasure is not possible.

●Is the erasure head dirty? (+ page 21)

●Is a metal tape being used?

High frequency sound is not emitted.

●Is the recording/playback head dirty? (+ page 21)

CD PLAYER’ SECTION

The CD player does not play.

●Is the disc correctly placed? (+ page 10)

●Is the disc dirty? (+ page 21)

●Is the lens affected by condensation?

+ Wait approximately one hour and try again.

To reset

If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.

1Press POWER to turn off the power.

2Press POWER to turn the power back on while pressing ■ CLEAR. Everything stored in memory after purchase is

canceled.

If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord, and connect it again. Then carry out step 2.

21 ENGLISH

Page 21 Page 23
Image 22
Page 21 Page 23
Contents MAR-903-21 98061 2CMY-Y-9 Digital AudioInstallation Explanation Graphical SymbolsElectric Power AC power cordSound Clock and TimerPreparations Radio Reception@ Surround speakers Positioning the Speakers~ Front speakers @ Center speaker Check the AC voltageConnect AC cord to an AC outlet Connect the right and left speakers to the main unitConnect the slurround speakers to the main unit Connect the center speakerConnecting AN Outdoor Antenna To dim the illumination of the display Super T-BASS SystemTo change the Iefthight balance When the music source is monaural To cancel the selected modeSound adjustment during recording To select with the remote controlSearch To search for a station quickly Auto SearchMono Press TAPE, then press W= to open the cassette holder Repeat steps 1Usable tapes Press to start playLoading Discs Playing DiscsCD PlmAYMIJG Press Prgm in stop mode Press numbered buttons O-9 and +10 to program a trackInsert the tap? to be recorded on into Deck Press on Dleck 1 to start recordingPress on Deck 1 to start recording on the first side Insert the tape into DeckPress CD and load the discs Press EDIT/CHECK m To stop recordingPress EDIT/CHECK to select side a and press on Deck Press CD and load the discs Press EDIT/CIHECK twiceRepeat for the rest of the tracks for side c1 a Press EDIT/CHECK for recording of the second sidePress Dolby PRO Logic to select Normal Press Manual Select Test again to stop the noise signalTo change the delay time Rear-mounted surround speakers enhance the ‘depthAdditional Dolby PRO Logicmodes To adjust the balance of connected speaker sound levelsTo select Phantom or 3 Stereo Enter Press Clocwdimmer once, then press EnterTurn Multi JOG to designate the hour, then press Turn Multi JOG to designate the minute, then press EnterGet ready for the Tape function or the timer recording Press Timer to display 0, then press Enter within 6 secondsPrepare the source Press VIDEO/AUX/PHONO CD Digital OUT Optical Jack0TH13@id#!&@@T10NS Play the connected equipmentVIDEO/AUX/PHONOIN L, R Listening to Dolby Digital Surround ~ SoundVIDEO/ AUX Phono 5.1CH Sound is emitted from one speaker only To clean the’ cabinetThere is no sound An erroneous display or a malfunction occursCompact Speaker svstem SX-ZR55Anotacion del propletario RiskofelectricshockExplication de Ios simbolos graficos Eneraia electricaRecepcion DE LA Radio PreparativesSonido Reproduction DE Cintas@Altavoces delanteros @ Altavoz central Ubicacion DE LOS AltavocesConexiones Compruebe la tension de CALa urtidad principal Conecte el cable de alimentacion de CA a una g toma de CAConecte Ias antenas suministradas ‘CONEXIONDEUNAANTENAEXTERIOR Para reetucir la intensidad de iluminacion del visualizador Gire Volume de la unidad principal o pulseVolume del control remoto Pulse T-BASSPulse uno de Ios botones del modo DSP Surround Pulse Tunewband para seleccionar la banda de FM o de AM Recepoioiu RE LA RadioDe AM Sintonizacion Mediante Numero DE Preajuste ~NTRODUCCION DE Discos REPRODUCCI$F4BE 4’M$COS CompactosProgramar una cancion Reproduction AleatoriaPulse b para iniciar la reproduction Para grabar parte de un disco compacto Inserte la cinta que vaya a grabar en la platinaPulse de la platina 1 para iniciar la grabacion Para borrar una grabacionInserte la cinta en la platina Para detener la grabacion Para designar ISIduration de la cintaPulse EDIT/CHECK para grabar la segunda cara Para cambiar el programa de cada caraPara parar la seiial de ruido, vuelva a pulsar Pulse Dolby PRO Logic para seleccionarNormal Manual Select TestModos Dolby PRO Logic Adicionales Phantom 3 StereoPara cambiar al modo de 24 horas Para cancelar el temporizador para dormirPulse Enter Si parpadea la visualization del relojPrepare la fuente de sonido Utilization de la unidad mientras este ajustado elPulse VIDEO/AUX/PHONO Tomas VIDEO/AUX/PHONO in ‘Toma SUB Woofer Haga la reproduction en el equipo conectadoWoofer 1CH Input Front L, RCH Input Center VIDEO/AUX/PHONO in L, RGeneralidades Seccion DE LA PlatinaSistema de altavoces SX-ZR55 Tipode caja Derechos DE AutorReference de I’utilisateur Explication des symboles graphiquesCourant electriaue SX-C606Prereglagede Stations Lecture DE Cassette PreparatifsReception Radio Lecture DE CDPositionnement DES Enceintes IRaccordez I’appareil video Raccordez Ies enceintes surround a I’appareil principalRaccordez I’erweinte centrale Raccordez Ie t@eviseur a I’appareil videoRaccordement D’UNE Antenne Exterieure DemoAppuyez sur T-BASS Controle DU VolumeSysteme Super T-BASS Pour attenuer I’eclairage de I’afficheurPour ajuster Ie volume des enceintes surround Pour annuler Ie mode selectionnePour selectionner Ie mode avec la telecommande DSPQuand une emission FM stereo contient des parasites RECEP’WMJ RadioAppuyez sur TL!NER/BAND pour selectionner la gamme FM ou AM Pour changer I’intervalle d’accord AMAppuyez sur Tape puis sur /4 pour ouvrir Ie porte-cassette Repetez Ies etapes 1 etPour effacer une station werectlee Appuyez sur pour commencer la lectureLecture DE Disques Chargement DES DisquesLecture Aleatoire Appuyez sur RANDOMde la telecommande’Appuyez sur Prgm en mode d’arri% Lecture RepeteeInserez la cassette a enregistrer clans la platine EnregistrementPreparatifs Appuyez sur de la platine 1 pour commencer ’enregistrementAppuyez sur CD et mettez Ies disques en place Repetez I’etape 5 pour Ie reste des plages de la face a Inserez la cassette clans la platineAmmvez sur EDIT/CHECK Dour commencer Repetee sur Dolby PRO Logic jusqu’a ce que Normal Appuyez sur Dolby PRO Logic pour =electionner NormalVerifiez Ies points suivants Pour changer Ie temps de retardPour changer Ie niveau sonore pendant la lecture Pour annuler Ie mode Dolby PRO LogicAutres Modes Dolby PRO Logic Pour selectionner Phantom ou 3 StereoPour afficher I’heure courante Quand vous utilisez la telecommandePour mettre’ Ie temporisateur hors service Pour passer au format de 24 heuresPreparez la source Preparez la fonction Tape ou I’enregistrement programmeMettez I’appareil raccorde en marche Prise CD Digital OUT OpticalAppuyez sur VIDEO/AUX/PHONO SUB WooferPrise du Iecteur DVD LCH Output Front L, R, etc .lCH Input Front L, RSection Platine a Cassette Droits D’AUTEUR 10,11,13,14 Name/Nombre/Nom Page/Pagina/PageOdeck 10,11,13

Z-VR55 specifications

The Aiwa Z-VR55 is a high-performance audio device that combines modern technology with elegant design, making it a sought-after choice for audio enthusiasts. This model stands out due to its exceptional sound quality and versatility, catering to the demands of both casual listeners and audiophiles.

One of the main features of the Aiwa Z-VR55 is its advanced digital signal processing (DSP) technology. This technology allows the device to deliver clear and detailed sound across various genres of music. The DSP optimizes audio output by adjusting to the acoustics of the surrounding environment, ensuring a balanced listening experience regardless of the setting.

Another noteworthy characteristic of the Z-VR55 is its Bluetooth connectivity. With built-in Bluetooth technology, users can easily stream music from their smartphones, tablets, or laptops without the hassle of wires. This feature enhances convenience, allowing users to enjoy their favorite tracks from a distance while maintaining high sound fidelity.

The Z-VR55 also supports multiple audio formats, including MP3, FLAC, and WAV, providing users with flexibility in their music choices. This capability ensures that whether one prefers high-resolution audio files or standard compressed formats, the Aiwa Z-VR55 can handle it effortlessly, delivering rich and dynamic sound reproduction.

In terms of design, the Aiwa Z-VR55 boasts a sleek and modern aesthetic. Its compact size makes it easy to integrate into any home audio setup or transport for on-the-go listening. The intuitive interface features straightforward controls that make operation simple, even for those who may not be tech-savvy.

Battery life is another critical aspect of the Z-VR55. Engineered for extended use, this device features a robust battery that supports hours of continuous playback on a single charge. This makes it an ideal choice for outdoor gatherings or long trips where access to a power source may be limited.

In summary, the Aiwa Z-VR55 is a versatile audio device that combines cutting-edge technology, high-quality sound output, and user-friendly features. With its DSP capabilities, Bluetooth connectivity, support for multiple audio formats, and stylish design, it caters to a wide audience, ensuring an enjoyable listening experience for everyone. Whether for home use or portable enjoyment, the Aiwa Z-VR55 is a remarkable addition to any audio collection.
Top Page Image Contents