![](/images/new-backgrounds/1041980/4198021x1.webp)
COOKER STABILITY
A stability bracket shall be secured firmly to the fabric of the building. For positioning of bracket (See Fig. 3). A safety chain should also be anchored firmly to the wall and cooker to prevent strain on the gas connection, when the cooker is withdrawn for servicing. When fitting a stability bracket and chain refer to Fig. 3, 3A and 3B.
Ranges must have an anti-tip bracket correctly installed as per these instructions. If you pull the range out from the wall for any reason, make sure that the device is properly engaged when you push the range back against the wall. If it is not, there is a possible risk of the range tipping over and causing injury if you or a child stand, sit or lean on an open door.
If disconnection of the restraining chain is necessary then ensure restraining chain is reattached as appliance is relocated in its original position.
CENTRE LINE OF | |
COOKER | SIDE VIEW |
|
WALL
BRACKET
Fig. 3B
FLOOR
To reduce the risk of tipping, the range must be secured by a properly installed anti-tip bracket supplied with the range. The bracket must be fitted within the shaded area shown in the diagram using 2 x screws (No. 10 x 1 1/4”) fixed in the wall or floor, longer screws may be required depending on the wall or floor covering.
AGA SIX-FOUR Series DC6 FFD Natural GAS and Propane GAS
Contents
Installation Section
Technical Data
Installation
Fitting and Product Dimensions
Electrical Connection
Electrical Connection
Connecting to GAS
Location
Side View
Cooker Stability
Pressure Testing
Levelling and Mobility Wheels
INSTALLATION/LEVELLING
Hotplate Castings
Fitting of Hotplate Casting and PAN Supports
Ultra Rapid Burner WOK Burner
Fitting Burner CAP Rapid and SEMI-RAPID Burners
Assembly of Rapid and SEMI-RAPID Burners
Desn 512995 a
Handrail Fitting
To Adjust PAN Support Level
Splashback
Users Guide
General Information
Important Notice Please Read the Accompanying Warranty
Child Safety
Safety Precautions and Hints
Desn 512646 B
Control Panel
To USE the Hotplate
GAS Hotplate
Important Safety Considerations
To FIT PAN Supports
Setting the Time of DAY
Setting UP the Cooker for USE
Storage and RE-HEATING of Food
Using the Simmering Oven Setting
Simmering Oven
Simmering Oven
Baked Potatoes
Ideas for the Simmering Oven
Recipes Ragout of Beef in Ale
Bread and Butter Pudding
Recipes Roast fillet of Lamb
Dauphinoise Potatoes
St Clements Pudding
Recipes
Gammon and Apricot Pie
Braised Red Cabbage
Frangipane and Apple Pudding
Meal Recipes
Chilli Con Carne
Broiling Oven
Food Suggested Heat Setting
Condensation
Ovens
General
Deep Fat Frying
Oven Cooking Guide
Cooking Hints
Roasting Oven
Yeast Mixture
Food Setting F Shelf Position Approximate Cooking Time
Baking Oven
Food Setting F
Yeast Mixtures
Food Setting F Approximate Cooking Time
Setting the Minute Timer
Minute Timer
Automatic Cooking Control
Setting the Automatic Cooking Program
Setting AN END Time only , Automatically
Cancelling a Program
To DE-ACTIVATE Keylock
Cleaning & Caring for Your Cooker
KEY Lock
To Activate Keylock Function
Do not USE Abrasives
Cooker Part and Finish Cleaning Method
Which MAY Clog the Pores
Do not USE ANY Cleaning Material
POWDERS, Soap Filled Pads Wire
WOOL, Spray CLEANERS, BRUSH-ON
Oven Shelves These shelves are designed to slide out
Fitting Burner CAP Rapid and SEMI-RAPID
Assembly of Rapid and SEMI-RAPID Burner
Ultra Rapid Burner
Servicing Section
Completely Isolate from Electric Supply Before Servicing
Servicing
Desn 512393 C
To Remove Facia Castings
To Remove Side Panels
To Remove Handrail see FIG
To Remove Timer
To Remove GAS TAPS/IGNITION Switches
To Remove Spark Generator
To Remove Grill Regulator
To Remove Oven Thermostats
To Remove Electrodes LH Burner
To Remove Electrodes LHR, CF, CR, RHR, RHF Burners
To Remove Thermocouple LHF Burner
To Remove Oven and Broiler Liners see FIG
To Remove Thermocouple LHR, RHR, RHF Burners
To Remove Oven FAN
To Remove Elements RH Ovens
To Remove FAN Oven Element
Page
Woodcrest Road Cherry Hill 800.633.9200