Whirlpool DU912 8051563 manual CancelingaCycle, Adding ItemsDuringa Cycle, UsingthePlateWarmer

		Use this cycle for loads				Use
		with normal amounts of				covered
		food soil. (The energy-				detergent
		usage label is based on				dispenser
		this cycle.)				section.
Wash	Rinse		Main	Purge†	Final	Dry	Time	Water
			Wash		Rinse		(min)	Usage
								(gal/L)
			●	●	●	●	62*	4.8/18.2
					140°F
					(60°C)
		Use this rinse cycle for				Do not
		rinsing dishes, glasses,				use
		and silverware that will				detergent
		not be washed right				with this
		away.				cycle.
Wash	Rinse		Main	Purge†	Final	Dry	Time	Water
			Wash		Rinse		(min)	Usage
								(gal/L)
	●						6	2.2/8.3

†A small amount of water runs through the pump to remove soil particles.

CancelingaCycle

You can cancel a cycle at any time.

1.Turn the Cycle Control knob slowly clockwise until you hear water draining. Let the dishwasher drain completely.

2.Open the door.

3.Turn the Cycle Control knob to OFF.

Changing aCycle orSetting

If your dishwasher has more than one wash cycle, you can change a cycle anytime during a cycle.

1.Lift the door latch to stop the cycle.

2.Press a cycle and, if desired, press an option.

3.Turn the Cycle Control knob clockwise.

4.Check the detergent dispensers. They must be filled properly for the new cycle.

NOTE: Turning the Cycle Control knob can cause the covered Detergent Dispenser section to open and release the detergent. Check the covered section if the cycle uses detergent in both sections.

5.Close the door firmly until it latches. The dishwasher starts a new cycle.

12

Adding ItemsDuringa Cycle

You can add an item anytime before the main wash starts, or the Cycle Control knob reaches Normal Wash.

To add items

1.Lift up the door latch to stop the cycle. Wait for the spraying action to stop before opening the door.

2.Open the door and add the item.

3.Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. This reduces the amount of moisture escaping from the vent when restarting a cycle.

4.Close the door firmly until it latches. The dishwasher resumes the cycle.

UsingthePlateWarmer

Use the Plate Warmer cycle to warm serving dishes or dinner plates.

NOTE: Do not use the Air Dry option.

1.Close and latch the door.

2.Turn the Cycle Control knob to PLATE WARMER.

3.Allow 8 minutes for the cycle to heat the dishware.

4.Turn the Cycle Control knob to OFF.

Option Selections

You can customize your cycles by pressing an option. If you change your mind, press RESET to turn the option off. Select a different option if desired.

You can change an option anytime before the selected option begins. For example, you can press an unheated drying option any time before drying begins.

After a wash cycle, the dishwasher remembers the options used and uses the same options in the next wash cycle, unless you select new options or press Reset.

Hi-Temp Wash

Select this option to heat the water to 140°F (60°C) in the main wash. This option adds heat and wash time. Heating the water helps improve washing results.

HI-

TEMP

WASH

NOTE: The Pots-N-Pans cycle automatically uses this option. Hi-Temp Wash is an option with the Heavy and Normal Wash cycles.