Whirlpool W10167841A Install Dishwasher, Prepare Dishwasher for Installation, A Bc E D

NOTE: It is recommended that the drain hose be looped up and securely fastened to the underside of the counter.

A

BC

E

D

A. Drain hose—cut here, if needed	D. Drain trap
B. Screw-type clamp	E. Waste tee
C. Drain hose

Install Dishwasher

WARNING

Tip Over Hazard

Do not use dishwasher until completely installed. Do not push down on open door.

Doing so can result in serious injury or cuts.

WARNING

Excessive Weight Hazard

Use two or more people to move and install dishwasher.

Failure to do so can result in back or other injury.

Prepare Dishwasher for Installation

1.Using 2 or more people, place the dishwasher on its back on a piece of cardboard.

2.Using a ¹⁄₄" hex socket, nut driver or Phillips screwdriver, remove the 4 screws attaching the toekick panel and lower panel to the dishwasher.

A

A. Screws

3.Remove both panels and set aside on a protected surface.

4.Apply thread seal tape to 90º elbow fitting and connect fitting to water inlet valve.

5.Tighten elbow until snug.

NOTE: Elbow should face to the rear of the dishwasher.

A

B

A. Water inlet valve

B.Elbow

6.Remove terminal box cover.

■Direct Wire—Install a U.L. listed/CSA certified clamp connector to the terminal box. If using conduit, use a U.L. listed/CSA certified conduit connector.

■Power Supply Cord—Install a power supply cord kit that is U.L. listed and marked for use with dishwashers (Part Number 4317824).

7.Measure the shortest opening height between the underside of the countertop and the floor where the dishwasher will be installed.

8.Extend leveling legs out from the dishwasher base, ¹⁄₄" less than the shortest opening height.

A

A. Leveling leg

11