INSTALLATION INSTRUCTIONS
WARNING
Electrical Shock Hazard
Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher.
Failure to do so can result in death or electrical shock.
1.Disconnect power.
2.Turn off water supply.
Prepare Cabinet Opening—Existing Utility
Hookups
Follow the steps in this section if you are installing the dishwasher in an existing cabinet opening with utility hookups.
1.Check that the water supply line reaches to the front
2.Check that the direct wire reaches to the front
6" (15.2 cm)
A
B
A. Water supply line
B. Direct wire
IMPORTANT: Always use a new drain hose even when installing a new replacement dishwasher.
3.Drill a 1¹⁄₂" (3.8 cm) diameter hole in the cabinet wall or floor on the side of the opening closest to the sink.
-
Connect Drain Hose to Air Gap—Waste Disposal
1.Remove the waste disposal knockout plug. Cut the end of the drain hose, if needed.
NOTE: Do not cut the ribbed section.
2.Attach the drain hose to the air gap with the large
NOTE: If the drain hose was cut, use 1¹⁄₂" to 2" (3.8 to 5 cm)
3.Use a rubber hose connector (not provided) with spring- or
B
C
D
|
| E |
H |
|
|
| G | F |
A. Drain | E. Drain hose | |
B. Spring- or | F. Rubber hose connector | |
C. Air gap | G. Disposal inlet | |
D. Large | H. Drain trap | |
4.Insert the drain hose through the hole cut in the cabinet and to the center front of the opening where the drain connection will be made.
A
A. Drain hose
Connect Drain Hose to Air Gap—No Waste Disposal
1.Cut the end of the drain hose, if needed. NOTE: Do not cut the ribbed section.
6