STARTING YOUR DISHWASHER
Starting a wash cycle
1.Load the dishwasher. See the “Loading Your Dishwasher” section.
6.Run hot water at the sink nearest the dishwasher until water is hot.
Turn off water.
2. | Spin the spray arms. They should turn | 7. Press a Cycle pad. If desired, press one |
| freely. | or more Options pads. See |
|
| the ”Setting the Controls” |
|
| section. |
|
| NOTE: Normal Wash, Light |
|
| Wash and Rinse Only share |
3. | Add detergent. See the “Using the | the same pad. The Cycle Control knob |
| Dispensers” section. | determines which cycle operates. |
| 8. Turn the Cycle Control knob clockwise to | |
| the desired cycle. You will | |
| feel a definite “stop” at each | |
| cycle mark. The dishwasher | |
4. Add rinse agent, if needed. | automatically starts the cycle | |
you select. | ||
| ||
| NOTE: If the door is latched, you will | |
| hear the cycles start and stop as the | |
| control knob passes each cycle mark. | |
| This is normal and does not hurt the | |
5. Close door firmly until it latches. | dishwasher. If you prefer, you can set | |
the Cycle Control knob with the door | ||
| ||
| unlatched. |
Stopping the dishwasher
You can stop your dishwasher anytime during a cycle. All you have to do is:
•Open the door slightly. Wait for any filling or spraying action to stop before opening the door all the way. Close the door to continue the cycle.
OR
•Turn the Cycle Control knob slowly clockwise until you hear water draining. Let the dishwasher drain completely. Then open the door and turn the Cycle Control knob to Off.
6