ENGLISH
Operations
■Notes:
•Before operating this receiver with the supplied remote control, refer to “Universal Remote Controls” on page 12 for details about operation.
•Before operating this receiver, first set this unit as desired for optimum performance, doing the system setup procedures. (For details, refer to “System Setup” on page 33.)
LISTENING TO A PROGRAm SOURCE
Before operation
•Enter the standby mode.
•The POWER ON/STANDBY indicator lights up amber. This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the operation readiness.
•To switch the power off, push the POWER switch again.
Then the power is cut off and the POWER ON/STANDBY indicator goes off.
1. In the standby mode, turn the power on.
•Each time the POWER ON/STANDBY button on the front panel is pressed, the receiver is turned on to enter the operating mode (the POWER ON/STANDBY indicator lights up blue) or off to enter the standby mode (the POWER ON/STANDBY indicator lights up amber).
•On the remote control, press the POWER ON button to enter the operating mode or press the STANDBY button to enter the standby mode.
2. Switch the speakers on.
• Then “SPK ON” is displayed for several seconds and the sound can be heard from the speakers connected to the speaker terminals.
•When using the headphones for private listening, press the SPEAKER button again to switch the speakers off. Then “SPK OFF” is displayed for several seconds (“H” indicator lights up.)
3. Select the desired input source.
•Each time the “VIDEO” on the front panel is pressed, the
input source changes as follows: → VIDEO 1 → V2/IPOD
•Each time the “AUDIO” button is pressed, the input source changes as follows:
→TUNER → CD → AUX → F.AUX
(Frequency display)
•Each time the “TUNER” button on the remote control is pressed, the band changes as follows:
→FM ST → FM MONO
18