Sherwood R-963 manual Tuning to preset stations, Scanning preset stations in sequence

3	Select the desired preset number(1~30)				4	Repeat the above steps			to to
	and press the MEMORY/ENTER button.					memorize other stations.
	TUNING/PRESET			MEMO/ENTER
					MEMORY BACKUP FUNCTION
When using the NUMERIC buttons on the remote					The following items, set before the receiver is turned
control.
					off, are memorized.
Examples)
					INPUT SELECTOR settings
For “3” :
		3			Surround mode settings
			within 2 seconds		Preset stations, etc.
For “15” :
		1	5		Note : If the electricity fails or the AC input cord is
For “30” :		0				disconnected for about 2 weeks, all
						memorized settings will be lost.
The station has now been stored in the memory.
When using the NUMERIC buttons, the station is stored
automatically without pressing the MEMORY/ ENTER
button.
A stored frequency is erased from the memory by storing
another frequency in its place.
If “MEMO” goes off, start again from the above step .
Tuning to preset stations					2	Select the desired preset number.
								TUNING/PRESET
1	After selecting the tuner as input source,
	select the preset tuning mode.
					When using the NUMERIC buttons on the remote
			T/P MODE		control.
					Examples)
					For “3”:		3
					For “15”:		within 2 seconds
							1	5
							0 (or 3	within 2 seconds	)
					For “30”:			0
Then “PRESET” lights up.					When selecting the desired preset number with the
					NUMERIC buttons, the desired preset station will be
					tuned to automatically without selecting the preset
					tuning mode.

Scanning preset stations in sequence

OSD	POWER
OFF	The receiver will start scanning the stations in the
	preset sequence and each station is received for 5
	seconds.
	At the desired station, press this button again to
	stop scanning.

ENGLISH

29