Using the OSD
This unit incorporates an
The OSD function uses a monitor TV connected to this unit as a display and has two kinds of display modes such as current status display and menu screen.
Notes: The OSD function is not available via the component video connection.
Any
CURRENT STATUS DISPLAY
This mode shows the status corresponding to each operation. The
Note : When watching a movie earnestly, if you want to turn off the current status display function, set the OSD mode to Off.(For details, refer to “When selecting the OSD MODE” on page 44.)
When selecting the desired input source. | When selecting the TEST TONE mode. |
VIDEO 1 (OPTICAL1)
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| FL : | |||||
Input |
| Signal input |
|
|
|
|
|
| ||
source | Channel level or overall volume display |
When adjusting each channel level or overall volume, the volume level display will be shown.
The test tone display will be shown until the test tone mode is canceled.
OSD Menu Settings
The OSD menu allows you to perform the setup procedures easily. In most situations, you will only need to set this once during the installation and layout of your home theater, and it rarely needs to be changed later. The OSD menu consists of 6 main menus: power amp assign, speaker setup, function select, surround setup, CH level trim and room 2 feed setup. Some of these menus are divided up into various
The OSD menu settings are performed easily with the CURSOR control( , | , | , | ), | |||||
RETURN and ENTER buttons. |
|
|
|
|
|
| ||
The “3”, “7”, “8” and “9” of the NUMERIC buttons do also work as the CURSOR control( , | , | , )buttons do. In | ||||||
this case, the “3” button stands for the CURSOR UP( | ) button, the “7” for the CURSOR LEFT( | ), the “8” for the | ||||||
CURSOR DOWN( ) and the “9” for the CURSOR RIGHT( ). |
|
|
|
|
| |||
Turn the menu screen on. |
|
|
|
|
|
| ||
1 |
|
| M A I N | M E N U |
|
| ||
|
|
|
|
| ||||
OSD |
|
| P O W E R | A M P A S S I G N |
| |||
OFF |
|
| S P E A K E R S E T U P |
|
| |||
|
| F U N C T I O N |
| S E L E C T |
| |||
| MAIN |
| S U R R O U N D S E T U P |
| ||||
VOL |
| CH | C H L E V E L T R I M |
|
| |||
|
|
|
|
| ||||
|
|
| R O O M 2 F E E D S E T U P |
| ||||
4 | 5 | 6 | O S D : Q u i t |
|
| E N T E R : S e l e c t | ||
1 | 2 | 3 |
|
|
|
|
|
|
7 | 8 | 9 |
|
|
|
|
|
|
| 0 |
|
|
|
|
|
|
|
MI | M2 | M3 | In the bottom of the display, “OSD” stands for the ON- | |||||
|
|
| ||||||
|
|
| SCREEN DISPLAY button, “RETURN” for “RETURN”, | |||||
The main menu will be shown. | “ENTER” for “ENTER”, “ | ”, “ | ”, “ | ” and “ ” for | ||||
To turn the menu screen off, press this button again. | CURSOR UP( ), DOWN( ), LEFT( | ) and RIGHT( ). |
ENGLISH
35