Sherwood R-963 manual Entering a Setup Code, Buttons simultaneously for 3 seconds

ENGLISH

ENTERING A SETUP CODE

•This remote control can control up to ten different components.

•Before operating audio and video components using the remote control supplied with this receiver, the setup code for each component should be entered.

•For system remote control operation, the setup code for each Sherwood component such as CD player, tape deck and DVD player(V-756, etc.) is “001” respectively. (However, the setup code for some Sherwood DVD player such as VD-4103, etc. is “112”, ”114” or “091”. Enter each setup code for CD player and tape deck doing

from step as follows.

Turn on the component you want to control.

1

Example) When entering the setup code for this receiver, turn on this receiver.

Note:

If you component has the discrete POWER ON and OFF buttons, please do not turn on the component manually.

Find the setup code for your component

2 referring to “Set-Up Code Table” in the operating manual of this remote control.

Example) The 3 digit setup codes for the Sherwood “Audio” are 001,024, ...(Hint:The correct setup code for this receiver is “001”.)

3	Press both the MAIN and ROOM 2(/ENTER)
	buttons simultaneously for 3 seconds.
	OSD
	OFF
				MAIN
	PAGE	MAIN	FAV
	VOL		CH
	1	2	3
	4	5	6	ROOM 2
	7	8	9
		0		ENT
	MI	M2	M3
		RNC-500

Then the setup menu will be displayed on the LCD screen.

Note:

If the display of the corresponding mode disappears, start again from the above step or the current mode.

Select the device corresponding to the

5 component you want to control. Example) When selecting the AUDIO for

receiver or amplifier, etc.

Select the Pre-PROgramming mode.

4

OSD POWER

OFF

Then the Pre-PROgramming menu will be displayed.

Select the device from which the appropriate

6 3 digit setup code table will be selected. Example) If it is the AUDIO code table,

select the AUDIO.

OSD	POWER	OSD	POWER
OFF		OFF

14