Sherwood RD-7502 manual System Setup, Navigating through the setup menu, Down

ENGLISH

System Setup

•The setup menu is displayed on the fluorescent display and allows you to perform the setup procedures easily. In most situations, you will only need to set this once during the installation and layout of your home theater, and it rarely needs to be changed later.

The setup menu consists of 5 main menus ; system , input, speaker setup, CH level and parameter. These menus are then divided up into various sub-menus.

Navigating through the setup menu

•The explanations here assume you are using the buttons on the remote control when performing the setup menu operation. However, you can use the buttons on the front panel as well.

The buttons on the front panel correspond to those on the remote control as shown below.

SETUP

ENTER

SETUP MEMO/ENTER CONTROL

1. Turn the setup menu on.

POWER ON		STANDBY
2	3	SLEEP
1
5	6	DIMMER
4
8	9	SETUP
7	MUTE
P.SCAN		VOLUME
0
D/A MODE CH.LEVEL
DISPLAY		SETUP
SEL	ENTER	SEL
T
ES

•The setup menu will be shown.

•To turn the menu off, press this button again.

3.Confirm your selection.

7

		MUTE
P.SCAN	0		VOLUME
D/A MODE		CH.LEVEL
DISPLAY			SETUP
SEL	ENTER		SEL
T					ENTER
T
E
S
ST	SEARCH MODE		OU	N	D
ER	EO
			RR
			SU
	SOUND		EXT.IN
TONE PARAMETER
TAPE	VIDEO 1	VIDEO 2	VIDEO 3
FM/AM/XM	CD	AUX

2. Select the desired menu using the CURSOR UP( ) /

DOWN(	) buttons.
	7	8	9
			MUTE
	P.SCAN	0		VOLUME
	D/A MODE		CH.LEVEL
	DISPLAY			SETUP
	SEL	ENTER		SEL
	T
	E
	S
	T
	ST	SEARC H MODE		OU	N	D
	ER	EO
				RR
				SU
		SOUND		EXT.IN
	TONE PARAMETER
	TAPE	VIDEO 1	VIDEO 2	VIDEO 3
	FM/AM/XM	CD	AUX

•When selecting “SYSTEM”, see “SETTING THE SYSTEM” on page 37.

•When selecting “INPUT”, see “SETTING THE INPUT” on page 39.

•When selecting “SPK SET”, see “SETTING THE SPEAKER SETUP” on page 41.

•When selecting “CH LEVEL”, see “SETTING THE CH LEVEL” on page 48.

•When selecting “PARAMTR”, see “SETTING THE SOUND PARAMETER” on page 50.

•When selecting “EXIT”, the setup menu will be turned off.

34