Sherwood RD-7502 manual About the speaker size, When selecting the Speaker Distance

Continued

4. Repeat the above steps 2 and 3 until the speakers are all set to the desired mode.

About the speaker size

•Select “L” (Large) or “S” (Small) not according to the actual size of the speaker but according to the speaker's capacity for playing low frequency (bass sound below frequency set on the SPEAKER CROSSOVER menu) signals.

•If you do not know, try comparing the sound at both settings (setting the volume to a level low enough so as not to damage the speakers) to determine the proper setting.

•When setting the speaker size by performing the auto setup, depending on whether the measured crossover frequency of each speaker is lower or higher than 80 Hz, its size is automatically set to “L" (Large) or “S" (Small). (For details, refer to "When selecting the SPEAKER CROSSOVER" on page 46.)

When selecting the SPEAKER DISTANCE

1. Press the CURSOR UP( )/DOWN( ) buttons to select the “DISTANCE”, then press the ENTER button.

7	8	9
		MUTE
P.SCAN	0		VOLUME
D/A MODE		CH.LEVEL
DISPLAY			SETUP
SEL	ENTER		SEL
T						ENTER
E
S
T
ST	SEARCH MODE		OU	N	D
ER	EO
			RR
			SU
	SOUND		EXT.IN
TONE PARAMETER
TAPE	VIDEO 1	VIDEO 2	VIDEO 3
FM/AM/XM	CD	AUX

2. Press the CURSOR UP( )/DOWN(									) buttons to select the desired item.
7
					MUTE
P.SCAN			0			VOLUME
D/A MODE					CH.LEVEL
DISPLAY						SETUP
SEL				ENTER		SEL			Note :
T									• You cannot select the subwoofer and the speakers set to
E
S
T
ST			SEARCH MODE			OU	N D		"N" (None).
ER		EO
						RR
						SU
TONE		SOUND			EXT.IN
	PARAMETER
TAPE		VIDEO 1			VIDEO 2 VIDEO 3
FM/AM/XM			CD		AUX
3. Press the CURSOR LEFT( )/RIGHT(									) buttons to set the selected item as desired.
7
					MUTE				When selecting the desired unit
P.SCAN						VOLUME
		D/A MODE CH.LEVEL
				0
DISPLAY						SETUP			• You can select either “M” (Meter) or “FT” (Feet).
SEL					ENTER		SEL		• Once a unit is selected, the distances are automatically
T									changed in the selected unit.
T
E
S
	ST			SEARCH MODE			OU	N D
			ER	EO
							RR
						SU
TONE				SOUND		EXT.IN			When setting the distance
			PARAMETER
TAPE				VIDEO 1 VIDEO 2 VIDEO 3					• You can set the distance within the range of 0.1 ~ 9.0
FM/AM/XM				CD	AUX

meters in 0.1 meter intervals (or 0 ~ 30 feet in 0.5 feet intervals).

4. Repeat the above steps 2 and 3 until the distances are all set as desired .

About the speaker distance

When enjoying multi-channel surround playback with Dolby Digital and DTS sources, etc., it is ideal that the center, surround and surround back speakers should be the same distance from the main listening position as the front speakers. By entering the distance between the listening position and each speaker, the delay times of center, surround and surround back speakers are automatically adjusted to create an ideal listening environment virtually as if the center, surround and surround back speakers were at their ideal locations respectively.

ENGLISH

45