12. CONNECTING MULTI-ROOM SYSTEM KIT
•The
For information on the
•IR IN jack allows you to control this receiver from another room with the remote control unit.
•To control this receiver from another room with the remote control unit, connect the IR IN jack to the output of the connecting block.
•If this receiver is located inside a cabinet or other enclosure where the infrared beams from the remote control unit cannot enter, then operation with the remote control unit will not be possible. In such a case, connect the IR IN jack to the output of the connecting block.
■Note:
•Remote operation may become unreliable if the IR receiver is exposed to strong light such as direct sunlight or inverted fluorescent.
13. CONNECTING XM DT (only for North America)
•Connect the XM DT terminal to the XM
•Position the XM
receive the best signal.
When making connections, also refer to the operating instructions of the XM
•For the best reception, check the signal strength of the XM radio signal with using
signal strength display mode, then adjust the position of the XM antenna until "SIGNAL : GOOD" is displayed. (For details, refer to "Displaying XM information" on page 42.)
•To listen to XM Satellite Radio, refer to "XM Satellite Radio (only for North America)" on page 40.
ENGLISH
13