Sherwood R-871 manual Programing the commands from other, Remote controls Learning mode

ENGLISH

Programing the commands from other	2	Press and hold down the ENTER
		button and the desired one of the
remote controls (LEARNING mode)
		DEVICE buttons for more than 2
• If the setup codes are not available for your		seconds.
component or you want to program a missing or
special function into one button of a device, the
learning function enables this remote control to
learn the commands from other remote controls.

Place this remote control and other 1 remote control facing each other at a distance of 5 to 15 cm (2 to 6 inches )

apart.

•Then “LEARN” is displayed on the LCD screen

for several seconds

■Note :

•During setting operation, to exit from the setting mode, press any of the DIVICE buttons.

3	While “LEARN” is displayed, press the	4	While “SEL” is flickering, on this remote
			control, press the button corresponding
	ENTER button.
			to the function to be learned.
		Example: If the function to be learned is playback,
			press the PLAY(▶) button.

• Then “SEL” is flickering.
• If “SEL” goes off, start again from the above		•Then “READY” is displayed.
step ②.		■Note:
		• You cannot program a function into some
		buttons such as DEVICE, MACRO and LIGHT
		buttons.
5	While “READY” is displayed, on the	6	While “SEL” is flickering, repeat the
	other remote control, press the button		above steps ④ and ⑤ to program all
	of the function to be learned.		the commands you want to the buttons
			on this remote control under the same
• If the command has been learned successfully,			device mode.
“OK” is displayed and then “SEL” is flickering.		■To exit from the setting mode, press any of the
• If “ERROR” is displayed and then “SEL” is		DEVICE buttons.
flickering, it means that for some reason the
command was not learned. In this case, repeat		7	Repeat the above steps ① to ⑥ to
the above steps ④ and ⑤.
			program the commands from a different
■Notes :
			remote control.

•If an incorrect signal has been sent or, in some cases, the command from other remote control

simply cannot be learned.	8	Operate the newly programmed buttons
• In some “ERROR” cases, the remote controls
		to make sure the learning function was
just need to be moved closer together or
		performed properly.
farther apart.

22