Sherwood R-871 Programming a macro function, Operating a macro function, To erase a macro program

ENGLISH

Programming a macro function		2	While “M1” is displayed, press the
			CURSOR UP(▲)/DOWN(▼) buttons to
• The macro function enables you to program a
			select the MACRO button to be
series of button operations(up to 15) on this			programmed into, then press the ENTER
remote control into a single button.			button.
• You can store up to three separate macro
command sequences into “M1”, “M2” and “M3”
buttons.
1	Perform the steps ③ and ④ in
	“Entering a setup code” procedure on
	page 20 to select the macro mode
	(“MACRO”).
• Then “M1” is displayed on the LCD screen for		• Each time the CURSOR UP(▲)/DOWN(▼) buttons
several seconds.
		are pressed, “M1”, “M2” or “M3” is selected.
• During macro setting operation, pressing any of
		• Then “SEL” is flickering.
the DEVICE buttons cannot exit from the macro
		• If “SEL” goes off, start again from the above
mode.
		step ①.
3	While “SEL” is flickering, press the	4	Press any of the MACRO buttons
	operation buttons you want to program		(M1~M3) to complete the programming.
	in order.
Example: When playing a DVD on the DVD player
	connected to VIDEO 2 jacks of this
	receiver.
1. Press “AUDIO” button to control this receiver.
2. Press “POWER ON” button to turn this
receiver on.
3. Press “VIDEO 2(7)” button to select the
desired input source.		• Then “OK” is displayed.
4. Press “DVD” button to control the DVD player.
5. Press “POWER ON” button to turn the DVD		■To erase a macro program
player on.		• When erasing a macro program, perform the
6. Press “PLAY (▶)” button to start playback.		above steps ①, ② and ④, but ignore the step ③.
		■To change a macro program
		• When a new macro program is stored into a
• Each time the operation buttons are pressed,		MACRO button with performing the above steps
		① to ④, the previous macro program is erased
the programmed order is displayed.
		from the memory of the MACRO button.

Operating a macro function

•Aim the remote control at the REMOTE SENSORs of the components to be controlled and press the MACRO button you want. Example: When pressing “M1” button.

■Notes:

•The codes programmed into a MACRO button will be transmitted at an interval of 0.5 seconds. However, some components may not be able to complete one operation in 0.5 seconds and may miss the next code.

In this case, the macro function cannot control the corresponding components correctly.

•Be sure to use the remote control within the remote control operation range of the components.

•Depending on the operation status of the components, etc., the macro function cannot control the corresponding components correctly.

24