BEFORE YOU CALL
Oven smokes excessively when | Incorrect setting. Follow broiling instructions in Setting Oven Controls section. |
broiling. | Meat too close to the broil element. Reposition broil rack to provide proper clearance |
| |
| between the meat and broil element. Remove excess fat from meat. Cut remaining |
| fatty edges to prevent curling, but do not cut into lean. |
| Grease build up on oven surfaces. Regular cleaning is necessary when broiling |
| frequently. Grease or food splatters will cause excessive smoking. |
|
|
Oven control panel beeps and | Oven control has detected a fault or error condition. Press Clear off key to clear the |
displays any F or E code error. | error code. Try Bake or Broil function. If the F or E code error repeats, turn OFF power |
| to appliance, wait 5 minutes and then repower appliance. Set clock with correct time of |
| day. Try Bake or Broil function again. If fault recurs, press Clear off to clear and call 1- |
| |
|
|
Soil not completely removed after | Self Clean was interrupted. Review instructions in Self Clean section. |
Self Clean. | Excessive spills on oven bottom. Clean before starting Self Clean. |
| |
| Failure to clean soil from the oven frame, the door liner outside the oven door gasket |
| and the small area at the front center of the oven bottom. These areas are not in the |
| |
| starting the |
| brush and water or a nylon scrubber. Be careful not to damage the oven gasket. |
|
|
Convection fan does not rotate. | Oven door is open. Convection fan will turn off if oven door is opened when Convection |
| is active. Close oven door. |
Oven racks discolored or do not slide easily.
Oven racks left in oven cavity during Self Clean. Always remove oven racks from oven cavity before starting a
Self Clean does not work. | Oven control not set properly. Review instructions in Self Clean section. |
34