Frigidaire FGES3045KB, FGES3065KF, FGES3065KB, FGES3045KF Setting the Sabbath Feature for use on

Page 31

SETTING THE SABBATH FEATURE (for use on

the Jewish Sabbath & Holidays)

The BAKE TIME and DELAY START pads are used to set the Sabbath feature. The Sabbath feature may only be used with the BAKE pad. The oven temperature may be set higher or lower after setting the Sabbath feature (the oven temperature adjustment feature should be used only during Jewish Holidays), however the display will not visibly show or provide any audible tones indicating whether the change occurred correctly. Once the oven is properly set using Bake with the Sabbath feature active, the oven will remain continuously ON until cancelled. This will override the factory preset 6-Hour Energy Saving feature.

If the oven light will be needed during the Sabbath, press OVEN LIGHT before activating the Sabbath feature. Once the oven light is turned ON and the Sabbath feature is active, the oven light will remain ON until the Sabbath feature is turned OFF. If the oven light needs to be OFF, be sure to turn the oven light OFF before activating the Sabbath feature.

To Program the Oven to Begin Baking Immediately & activate the Sabbath feature (example: baking at 350°F)

1.Be sure that the clock is set with the correct time of day.

2.Place the food in the oven.

3.Press BAKE. “350°” appears in the display.

4.Press START. The actual oven temperature appears in the display.

5.If you desire to set the oven control for a Bake Time or Delayed Bake Time do so at this time. If not, skip this step and continue to step 7. Refer to the Bake Time / Delay Start section for complete instructions. Remember the oven will shut down after using Bake Time or Delay Start and therefore may only be used once during the Sabbath/Jewish Holidays.

6.The oven will turn ON and begin heating.

7.Press and hold both the BAKE TIME and DELAY START pads for at least 3 seconds. “SAb” will appear in the display. Once “SAb” appears in the display the oven control will no longer beep or display any further changes and the oven is properly set for the Sabbath feature.

8.The oven may be turned OFF at any time by first pressing CANCEL pad (this will turn the oven OFF only). To turn OFF the Sabbath feature press and hold both the BAKE TIME and DELAY START pads for at least 3 seconds. “SAb” will disappear from the display.

IMPORTANT

It is not advised to attempt to activate any other program feature other than BAKE while the Sabbath feature is active. ONLY the following key pads will function after setting the Sabbath feature; 0 to 9, BAKE, START & CANCEL. All other keypads should not be used once the Sabbath feature is properly activated.

SETTING OVEN CONTROLS

NOTE

You may change the oven temperature once baking has started by pressing BAKE, the numeric key pads for the temperature you want (example for 425°C press 4 2 5) and then pressing START twice (for Jewish Holidays only). Remember that the oven control will no longer beep or display any further changes once the oven is set for the Sabbath feature.

Should you experience a power failure or interruption, the oven will shut off. When power is returned, “SF” (Sabbath Failure) will be shown in the oven display and the cooktop displays (models B & C). The oven and cooktop will not turn back on automatically. If your food was nearly fully cooked, you may allow the trapped heat in the oven to finish the cooking process. Otherwise, you should remove the food when the power failure occurs, because you may only start the oven once during the Sabbath/Jewish Holidays. After the Sabbath observance, turn OFF the Sabbath feature and be sure that all the control knobs are at the OFF position. The appliance may be used again with all normal functions.

After the Sabbath observance turn OFF the Sabbath feature. Press and hold both the BAKE TIME and DELAY pads for at least 3 seconds. “SAb” will disappear from the display and the oven may be used with all normal functions. For further assistance, guidelines for proper usage, and a complete list of models with the Sabbath feature, please visit the web at http:\\www.star-k.org.

How the Electronic Surface Element Controls work when the Sabbath feature is ON. (model B & C only)

When your Oven Sabbath feature is ON, the Electronic Surface Elements are also in Sabbath mode. This means that all electronic surface element control displays show “Sb”. The surface elements can be used even if the Sabbath Feature is on.

To turn ON a Surface Element when the Oven Sabbath Feature is active:

If you turn on a surface element when the oven Sabbath feature is on, the electronic surface element control will record that request and execute it with a 15-30 seconds delay. So the element will start heating 15-30 seconds after the surface element control was turned on. As the oven control, the surface element display will not show the setting because “Sb” is on in the displays. When necessary, it is possible to adjust the power of the surface element but you have to remember that the surface element control will adjust the temperature with the same delay.

To turn OFF the Surface Element when the Oven Sabbath Mode is active:

To shut off the surface element while the Sabbath feature is ON, proceed as usual but take note that the element will immediately turn off without any delay.

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Use &Care Register Your Product Welcome & CongratulationsPlease Carefully Read and Save These Instructions Definitions Important Safety InstructionsImportant Instructions for Using Your Cooktop Do Not Use Decorative Surface Burner Covers Important Safety Instructions for Using Your OvenImportant Safety Instructions for Cleaning Your Oven For Glass Cooktop onlyYour built-in range Features Features AT a Glance Model aFeatures AT a Glance Model B Features AT a Glance Model C About the ceramic glass cooktop Before Setting Surface ControlsElement on & hot surface indicator lights Element on indicator light locationEsec error indicator message Er Available Esec display settingsEsec power failure indicator message PF Esec hot element indicator message HECookware material types Using proper cookwareModel a Setting Surface ControlsTo Operate the Dual Surface Element To Operate the Bridge Surface Element Keep warm zone Models B & C only Arranging oven racks Before Setting Oven ControlsOven vent location Air circulation in the ovenFlat handle oven rack Offset oven rack Types of oven racksTo assemble the Effortless Oven Rack system Effortless oven rack systemNever pick up hot oven rack parts Feature and function follow later in this Use & Care Guide Setting Oven ControlsControl pad features Temperature Visual DisplayChanging Between 12 or 24 Hour Time of DAY Display Minimum and Maximum Control PAD SettingsSetting the Clock Feature Minimum TEMP. /TIME Maximum TEMP. /TIMESetting Temperature Display Fahrenheit or Celsius Setting Continuous Bake or 6 Hour Energy SavingSetting Silent Control Operation Setting ADD 1 Minute Feature some models Setting Minute TimerSetting Lockout Feature To set the Bake Temperature to 375F Setting Quick or Powerplustm PreheatSetting Bake To set the Preheat temperature for 375FConvection Baking Tips Setting Convection BakeBenefits of Convection Bake Convection Roasting Tips Setting Convection ConvertSetting Convection Roast To set a Convection Roast Temperature of 375FElectric Oven Convection Broiling Table Recommendations Setting Convection Broil some modelsTo set a Convection Broil Temperature of 500F Convection Broiling TipsBAKE, Convection BAKE, Bake Time and Delay Setting Bake TimeSetting Delay Start When the timed bake finishesCancel Setting Keep WarmSetting Pizza some models Delayed Bake TimeSetting MY Favorite some models Setting Chicken NuggetsTo set a Broil of 500F Setting BroilBroiling Tips Electric Oven Broiling Table RecommendationsSetting the Sabbath Feature for use on Oven Light Adjusting Oven TemperatureTo adjust the oven temperature higher To adjust the oven temperature lowerAdhere to the following cleaning precautions SELF-CLEANINGWhat to Expect during Cleaning When the Self-Clean Cycle is Completed Setting SELF-CLEAN Cycle Time LengthStopping or Interrupting a Self-Cleaning Cycle To set the keep warm drawer controls Keep warm drawer temperature selectionKeep warm drawer rack positions Operating the keep warm drawerCleaning various parts of your appliance Care & Cleaning Cleaning ChartFor light to moderate soil Care & CleaningCeramic glass cooktop cleaning & maintenance Cleaning recommendations for the ceramic glass cooktopRemoving and replacing the lift-off oven door Care and cleaning of stainless steelTo Replace the Light Bulb To remove the hidden bake cover some modelsChanging oven light Be Sure Oven is CoolTo remove and replace keep warm drawer some models Oven baking Pitting or rusting Possible CAUSE/SOLUTIONSurface units too hot or not hot enough Drip bowls areOccurrence Exclusions This warranty does not cover the following Major Appliance WarrantyDisclaimer of Implies Warranties Limitation of Remedies
Related manuals
Manual 5 pages 18.45 Kb
Top Page Image Contents