GE JBP75, JBP63, JBP77, JBP76 owner manual Connector block terminal Bare wire

Page 39

7 4-Wire Conduit Installation

Remove the 3 screws from the connector block. Remove the grounding strap from the connector block middle location and the screw connecting it to the frame of the range. Insert bare wires between the connector block terminals and movable nuts. Tighten screws securely. Attach ground wire to the frame of the range.

WARNING: Connector block is approved for copper wire connection only. If aluminum wire is used, see note below.

NOTE: ALUMINUM WIRING

a Do not connect aluminum wire to connector block.

Use copper building wire rated for the correct amperage and voltage to make 3 (three) 3″ copper jumper wires. Connect wire as per Step 6 or 7 depending on number of wires.

b Splice copper wires to aluminum wiring using special connector terminals designed and UL-approved for joining copper to aluminum and follow the connector manufacturer’s recommended procedure closely.

Wire used, location and enclosure of splices, etc., must conform to good wiring practices and local codes.

	Screw	Bare wire tips
	Connector block	Bare wire tips
	Connector block
	Connector block terminal
Bare wire		Grounding
Bare wire		plate
Movable nut	Flexible cable
	Flexible cable
	Bracket	Conduit
		Conduit

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

39

Image 39

Contents GE Answer Center GE AppliancesYou can find them on a label behind Staple sales slip or cancelled check hereCongratulations You Are Now Part of the GE Family Write the model and serial numbers hereGE & You Service Partnership California Safe Drinking Water and Toxic Enforcement Fiberglass insulation in self-clean ovens gives off a verySmall amount of carbon monoxide during the cleaning cycle All ranges can tip and injury could resultSafety Precautions Safety Information When Cooking PORK… Oven SELF-CLEANING Oven Radiant Surface Units Page Instructions Safety Information REMEMBER… About the radiant surface units… Using the surface unitsHow to Set Indicator LightsSelecting types of cookware Instructions Using the oven controlsOven on Light Oven Control SettingsBefore you begin… Using the ovenAluminum Foil Preheating and Pan PlacementHow to Set the Oven for Broiling Troubleshooting Tips Customer ServiceComments Broiling guideUsing the clock and timer Press Start Time ON/OFF Automatic StopMake sure the oven clock shows the correct time of day Press Cook Time ON/OFFFor Models with Only an Oven Temperature Knob For Models with Pads and an Oven Temperature KnobLatch Door Indicates the thermostat will be set 20F. cooler How to Set the Oven for Cleaning Using the self-cleaning ovenBefore a Clean Cycle Customer Service TroubleshootingPress the Start Time ON/OFF pad How to Delay the Start of CleaningAfter a Clean Cycle Troubleshooting Tips Customer ServicePainted Surfaces Care and cleaning of the rangeControl Panel and Knobs Oven VentDo not lift the door by the handle To clean the inside of the doorTo clean the outside of the door Lift-Off Oven DoorTo remove the cover Oven Light Replacement on some modelsOven Heating Elements Oven ShelvesBroiler Pan & Grid To remove the storage drawerTo replace the storage drawer National Parts Center Cleaning the glass cooktopDaily Cleaning For heavy, burned-on soilSpecial Care Wiring must conform to National Electric Codes Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeStrain relief, they can be removed for better fit Power Cord Strain Relief InstallationDo not remove ground strap connection Wire Power Cord InstallationBefore After Wire Conduit Installation Connector block terminal Bare wire Anti-Tip Bracket Installation Leveling the RangeFinal Check Before you call for service… Off and on Blank or indicatorWhen range is Frequent cyclingBroil properly At Broil Food does not bakeOr roast properly Food does notSelf-clean cycle Oven temperatureClock and timer Self-cleanOven door will Oven not cleanAfter a clean cycle Excessive smokingA number Is on when youPower outage Want to cookWhat GE Will Not Cover GE Electric Range WarrantyFive Years Replacement glass cooktop if it should crack due We Will Replace, At No Charge To YouService Telephone Numbers In-Home Repair Service 800-GE-CARESTDD 800-TDD-GEAC