GE JBP75 Power Cord Strain Relief Installation, Strain relief, they can be removed for better fit

Page 35

3 Power Cord Strain Relief Installation

	Remove the lower rear range wiring cover to expose the connector block
a
	and bracket.
	Remove the knockout ring (13⁄8″) located on bracket directly below the
b
	connector. To remove the knockout, use a pair of pliers to bend the
	knockout ring away from the bracket and twist until ring is removed.

	Knockout ring in bracket.	Knockout ring removed.
	Assemble the strain relief in the hole. Insert the power cord through the
c
	strain relief and tighten. Allow enough slack to easily attach the cord
	terminals to the connector block. If tabs are present at the end of the winged
	strain relief, they can be removed for better fit.

	NOTE: Do not install the power cord without a strain relief.

	Connector box
				Ground
				strap


Wiring cover						Bracket
(shown removed)


	Strain relief		Power cord			Strain relief bracket
						(Provided with range cord. Not part of range.)
						(Provided with range cord. Not part of range.)

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

35

Image 35

Contents GE Answer Center GE AppliancesYou can find them on a label behind Staple sales slip or cancelled check hereCongratulations You Are Now Part of the GE Family Write the model and serial numbers hereGE & You Service Partnership California Safe Drinking Water and Toxic Enforcement Fiberglass insulation in self-clean ovens gives off a verySmall amount of carbon monoxide during the cleaning cycle All ranges can tip and injury could resultSafety Precautions Safety Information When Cooking PORK… Oven SELF-CLEANING Oven Radiant Surface Units Page Instructions Safety Information REMEMBER… About the radiant surface units… Using the surface unitsHow to Set Indicator LightsSelecting types of cookware Instructions Using the oven controlsOven on Light Oven Control SettingsBefore you begin… Using the ovenAluminum Foil Preheating and Pan PlacementHow to Set the Oven for Broiling Troubleshooting Tips Customer ServiceComments Broiling guideUsing the clock and timer Press Start Time ON/OFF Automatic StopMake sure the oven clock shows the correct time of day Press Cook Time ON/OFFLatch Door Indicates the thermostat will be set 20F. cooler For Models with Only an Oven Temperature KnobFor Models with Pads and an Oven Temperature Knob How to Set the Oven for Cleaning Using the self-cleaning ovenBefore a Clean Cycle Customer Service TroubleshootingPress the Start Time ON/OFF pad How to Delay the Start of CleaningAfter a Clean Cycle Troubleshooting Tips Customer ServicePainted Surfaces Care and cleaning of the rangeControl Panel and Knobs Oven VentDo not lift the door by the handle To clean the inside of the doorTo clean the outside of the door Lift-Off Oven DoorTo remove the cover Oven Light Replacement on some modelsOven Heating Elements Oven ShelvesTo replace the storage drawer Broiler Pan & GridTo remove the storage drawer National Parts Center Cleaning the glass cooktopDaily Cleaning For heavy, burned-on soilSpecial Care Wiring must conform to National Electric Codes Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeStrain relief, they can be removed for better fit Power Cord Strain Relief InstallationDo not remove ground strap connection Wire Power Cord InstallationBefore After Wire Conduit Installation Connector block terminal Bare wire Final Check Anti-Tip Bracket InstallationLeveling the Range Before you call for service… Off and on Blank or indicatorWhen range is Frequent cyclingBroil properly At Broil Food does not bakeOr roast properly Food does notSelf-clean cycle Oven temperatureClock and timer Self-cleanOven door will Oven not cleanAfter a clean cycle Excessive smokingA number Is on when youPower outage Want to cookWhat GE Will Not Cover GE Electric Range WarrantyFive Years Replacement glass cooktop if it should crack due We Will Replace, At No Charge To YouTDD 800-TDD-GEAC Service Telephone NumbersIn-Home Repair Service 800-GE-CARES