GE JBP77 Excessive smoking, Oven door will, Not unlock, Oven not clean, After a clean cycle

Page 45

Problem		Possible Causes	What To Do

Excessive smoking		Excessive soil.	• Turn the Oven
			Temperature knob to OFF.
			Open the windows to rid
			the room of smoke. Wait
			until the LATCH DOOR
			light goes off. Wipe up the
			excess soil and reset the
			clean cycle.
Oven door will		Oven too hot.	• Allow the oven to cool
not unlock			below locking temperature.
Oven not clean		Oven controls not	• See Using the self-cleaning
after a clean cycle		properly set.	oven section.

		Oven was heavily soiled.	• Clean up heavy spillovers
			before starting the clean
			cycle. Heavily soiled ovens
			may need to self-clean
			again or for a longer
			period of time.

LATCH DOOR light		Oven controls not	• Move the door latch
flashes		properly set.	handle to the right before
			setting the Oven
			Temperature knob to
			AUTO SELF CLEAN.

Oven door is		The door is out	• Because the oven door is
crooked		of position.	removable, it sometimes
			gets out of position during
			installation. To straighten
			the door, push down on
			the high corner.

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

45

Image 45

Contents GE Answer Center GE AppliancesCongratulations You Are Now Part of the GE Family Staple sales slip or cancelled check hereWrite the model and serial numbers here You can find them on a label behindGE & You Service Partnership Small amount of carbon monoxide during the cleaning cycle Fiberglass insulation in self-clean ovens gives off a veryAll ranges can tip and injury could result California Safe Drinking Water and Toxic EnforcementSafety Precautions Safety Information When Cooking PORK… Oven SELF-CLEANING Oven Radiant Surface Units Page Instructions Safety Information REMEMBER… How to Set Using the surface unitsIndicator Lights About the radiant surface units…Selecting types of cookware Instructions Using the oven controlsOven on Light Oven Control SettingsBefore you begin… Using the ovenHow to Set the Oven for Broiling Preheating and Pan PlacementTroubleshooting Tips Customer Service Aluminum FoilComments Broiling guideUsing the clock and timer Make sure the oven clock shows the correct time of day Automatic StopPress Cook Time ON/OFF Press Start Time ON/OFFFor Models with Only an Oven Temperature Knob For Models with Pads and an Oven Temperature KnobLatch Door Indicates the thermostat will be set 20F. cooler Before a Clean Cycle Using the self-cleaning ovenCustomer Service Troubleshooting How to Set the Oven for CleaningAfter a Clean Cycle How to Delay the Start of CleaningTroubleshooting Tips Customer Service Press the Start Time ON/OFF padControl Panel and Knobs Care and cleaning of the rangeOven Vent Painted SurfacesTo clean the outside of the door To clean the inside of the doorLift-Off Oven Door Do not lift the door by the handleOven Heating Elements Oven Light Replacement on some modelsOven Shelves To remove the coverBroiler Pan & Grid To remove the storage drawerTo replace the storage drawer Daily Cleaning Cleaning the glass cooktopFor heavy, burned-on soil National Parts CenterSpecial Care Wiring must conform to National Electric Codes Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeStrain relief, they can be removed for better fit Power Cord Strain Relief InstallationDo not remove ground strap connection Wire Power Cord InstallationBefore After Wire Conduit Installation Connector block terminal Bare wire Anti-Tip Bracket Installation Leveling the RangeFinal Check Before you call for service… When range is Blank or indicatorFrequent cycling Off and onOr roast properly Food does not bakeFood does not Broil properly At BroilClock and timer Oven temperatureSelf-clean Self-clean cycleAfter a clean cycle Oven not cleanExcessive smoking Oven door willPower outage Is on when youWant to cook A numberFive Years Replacement glass cooktop if it should crack due GE Electric Range WarrantyWe Will Replace, At No Charge To You What GE Will Not CoverService Telephone Numbers In-Home Repair Service 800-GE-CARESTDD 800-TDD-GEAC