GE JBP76, JBP63, JBP77, JBP75 owner manual Wire Conduit Installation

Page 38

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

6 3-Wire Conduit Installation

Remove the 3 screws from the connector block. Insert bare wires between the connector block terminals and movable nuts. Tighten screws securely. Do not remove ground strap connection.

WARNING: Connector block is approved for copper wire connection only. If aluminum wire is used, see note below.

NOTE: ALUMINUM WIRING

a Do not connect aluminum wire to the connector block.

Use copper building wire rated for the correct amperage and voltage to make 3 (three) 3″ copper jumper wires. Connect wire as per Step 6 or 7 depending on number of wires.

b Splice copper wires to aluminum wiring using special connector terminals designed and UL-approved for joining copper to aluminum and follow the connector manufacturer’s recommended procedure closely.

Wire used, location and enclosure of splices, etc., must conform to good wiring practices and local codes.

Screw
Connector block	Bare wire tips
Connector block terminal
Bare wire
Movable nut
Flexible cable
Bracket	Conduit
	Conduit

38

Image 38

Contents GE Appliances GE Answer CenterWrite the model and serial numbers here Staple sales slip or cancelled check hereCongratulations You Are Now Part of the GE Family You can find them on a label behindGE & You Service Partnership All ranges can tip and injury could result Fiberglass insulation in self-clean ovens gives off a verySmall amount of carbon monoxide during the cleaning cycle California Safe Drinking Water and Toxic EnforcementSafety Precautions Safety Information When Cooking PORK… Oven SELF-CLEANING Oven Radiant Surface Units Page Instructions Safety Information REMEMBER… Indicator Lights Using the surface unitsHow to Set About the radiant surface units…Selecting types of cookware Using the oven controls InstructionsOven Control Settings Oven on LightUsing the oven Before you begin…Troubleshooting Tips Customer Service Preheating and Pan PlacementHow to Set the Oven for Broiling Aluminum FoilBroiling guide CommentsUsing the clock and timer Press Cook Time ON/OFF Automatic StopMake sure the oven clock shows the correct time of day Press Start Time ON/OFFLatch Door Indicates the thermostat will be set 20F. cooler For Models with Only an Oven Temperature KnobFor Models with Pads and an Oven Temperature Knob Customer Service Troubleshooting Using the self-cleaning ovenBefore a Clean Cycle How to Set the Oven for CleaningTroubleshooting Tips Customer Service How to Delay the Start of CleaningAfter a Clean Cycle Press the Start Time ON/OFF padOven Vent Care and cleaning of the rangeControl Panel and Knobs Painted SurfacesLift-Off Oven Door To clean the inside of the doorTo clean the outside of the door Do not lift the door by the handleOven Shelves Oven Light Replacement on some modelsOven Heating Elements To remove the coverTo replace the storage drawer Broiler Pan & GridTo remove the storage drawer For heavy, burned-on soil Cleaning the glass cooktopDaily Cleaning National Parts CenterSpecial Care Installation of the range Wiring must conform to National Electric CodesPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Strain relief, they can be removed for better fitWire Power Cord Installation Do not remove ground strap connectionBefore After Wire Conduit Installation Connector block terminal Bare wire Final Check Anti-Tip Bracket InstallationLeveling the Range Before you call for service… Frequent cycling Blank or indicatorWhen range is Off and onFood does not Food does not bakeOr roast properly Broil properly At BroilSelf-clean Oven temperatureClock and timer Self-clean cycleExcessive smoking Oven not cleanAfter a clean cycle Oven door willWant to cook Is on when youPower outage A numberWe Will Replace, At No Charge To You GE Electric Range WarrantyFive Years Replacement glass cooktop if it should crack due What GE Will Not CoverTDD 800-TDD-GEAC Service Telephone NumbersIn-Home Repair Service 800-GE-CARES