GE JGBC18, JGBS18 manual About 2 turns, With the base. To prevent damage, do not overtighten spud

Page 43

HOW TO CONVERT A STANDARD ~lN

BURNER RANGE FOR USE WITH 1P GAS OR

NATUU GAS

~is range leaves the factory set for use with natural gas. If you convert to LP gas, keep these instructions and otices in case you want to convert back to natural gas.

The conversion should be done by a qualified technician or installer.

TOOLS REQUIRED:

1/2” open-end wrench

Flat blade screwdriver (small)

Nut drivers: 5/16” or a small adjustable (depending on the size of the spuds)

❑PREPARE ~GE FOR CONVERSION

(1)Turn off gas supply at the wM.

(2)Turn off the electid power to the range.

If range has not yet been connected to gas supply, or if fletible connection was made, range may be pulled out from the wall to make conversion easier.

❑CONVERT THE PRESSURE REGUWTOR

W_NG: Do not remove tie pressure regulator from tie range.

1.Remove the cooktop and locate the pressure regulator at right rear of the range.

NAT

—

 

LP

Cap

@

 

Cap

 

 

Gas Flow

w

 

 

 

 

 

o Ran

 

own

USH

DOWN TO OPEN.

2.Use a coin to remove the cap from the pressure regulator.

3.Turn the cap over and hook it into the slots. The type of gas to be used should now be visible on the top of the cap.

❑CONVERTING SURFACE BURNERS

1.Lift cooktop.

2.Lift burner assemblies straight up and

set aside to gain access to surface burner spuds.

3.With a 5/16” or small adjustable wrench, remove each of the four spuds on the surface burner gas inlet tubes and replace them

with the correct gas “ spuds mounted in a holder at the right rear of the range, above

the regulator. Natural gas spuds are brass and LP gas spuds are red or silver. (Mount the spuds that you removed from the inlet tubes back in the holder.) To prevent leakage, make sure spuds are securely screwed into gas inlet tubes.

4.Replace the burner assemblies.

5.Keep all spuds with your range so you have them if you move or get a different gas hook-up.

Top Burner

Ofice Dtill Sk

Color

Natural Gas

#54 (.0550 Dia.)

Brass

LP (Propane)

#66 (.0330 Dia.)

Red or Silver

 

 

 

 

 

 

❑CONVERT THE OVEN BURNER ORIFICES

Oven Burner

1.Remove oven door, storage drawer or broiler drawer, oven bottom and burner baffle (on some models), The lower burner orifice spud is located behind the storage drawer, broiler drawer or kick panel. (On some models, a metal shield must be removed to access the orifice.)

2.To convert to U gas, use a “’.,.,,

1/2” wrench to turn the lower\.. ..,,

burner ortice spud clockwise.

+

m

Tighten the spud only until it is ‘ snug. To prevent damage, do not overtighten the spud.

To convert to natural gas, loosen the spud

about 2 turns.

Broil Burner (on some models)

To convert to LP gas, use a 1/2” wrench to turn the upper burner otice spud clockwise. Tighten spud only until it is snug

with the base. To prevent damage, do not overtighten spud.

To convert to natural gas, loosen the spud

about 2 turns.

43

Page 42 Page 44
Image 43
Page 42 Page 44
Contents Operating Instructions, Tips Safe~If you received a damaged range Save time and money. Before you request serviceRead this guide carefully Write down the model and serial numbersUsing Your Range When You Get Your RangeAlways heat fat slowly, and watch as it heats Wortant SAFE~ ~STRUCTIONSCleating Your Range Baking, Broiling and RoastingDo no$ leave any items on the cooktop ~Sealed Burners Features of Your RangeSurface Burner Control Knobs Oven Light OtiOff Switch on some modelsSurface Burners, Grates and Drip Pans on some models Oven ControlTo Your OLD Om? Before Lighting a Burner Surface Burner ControlsTo Light a Surface Burner Can be dangerous. Placing How to Select Flame SizeAfter Lighting a Burner Top-of-Range CookwareTimer To Set the TimerTo Change or Cancel the Timer Setting Display Clock While Timer Is OperatingOven Control Before Using Your OvenPower Outage -Electric Ignition Power Outage -Stinding PilotShelf on the shelf support Oven ShelvesShelf Positions Oven VentsPreheating How to Set Your Range for BakingPan Placement Oven Shelves Arrange theoven ~Pies Baking GuidesCookies Aluminum FoilTo Adjust the Thermostat Adjust the Oven ThewostatUse of Aluminum Foil Dual Shelf CookingFrozen Roasts Questions and AnswersShould I salt the meat before broiling? Why are my meats not turning out as brown as they should?BRO~~G GU~E Sealed Burner Assemblies on some models ‘ediu1mw @’arg’IRemove the grates and ~ lift out the drip pans Standard win Burners on some modelsCooktop Surface Burner GratesOven Bottom Broiler Pan and Grid Oven Light Bulb on some modelsControl Panel and Knobs Removable Broiler Drawer on some modelsRemovable Storage Drawer on some models Oven Air VentsRemovable Kick Panel on some models Outside of door Lift-Off Oven DoorTo remove the door, u Do not immerse door in water Inside of doorOven bottom has a porcelain enamel finish To Clean the Continuous-Cleaning OvenJGBS04 JGBS06 JGBS07 For Your SafetyLM~RTANT Safety Instructions General PRovlDEADEQuATE GAS Supply Rigid Pipe HookupforModels Equipped with Sealed Burners Connect the Wnge to GX~~~~Ada,FN,eupfw Grounding ELECTRlmL Connections on some modelsElectric Disconnect ELECTRl~L ConnectionsLight the Pilots Manifold panelQuali~ of Flames Light the PilotsCheck Ignition of Surface Burners Sutiace Burner IgnitionTo remove the burner btifle on some models To remove the oven bottomAdjusting the AIR Adjustment Oven racks. E using a spirit level, take two Adjustable wrench to backInstall the oven shelves Range where it will be installed~ Converting Surface Burners On some models, you may have to remove an access cover alsoTools Required Convert the Pressure REGU~TOROrifice Spuds for Convetiing to Natural Gas Orifice Spuds for Converting to LPGasOven Burner Check for L~KS Adjust LOW FME SettingYeUow flames Normal for natural gasWith the base. To prevent damage, do not overtighten spud About 2 turnsSurface knobs to LOW Convert AIR Adjustment ShutterAdjust Oven Thermostat With baffle in place, flames Screw$URPACE RU~RS Light but Oven RAtiOW E~CT 800.626.2000 Consumer information serviceTimes oven is used. This is temporary Wdll Be There JGBS06 JGBS20 JGSS05 JGBS17 JGBS22 Jgbc JGBS04 JGBS18 JGBS23JGBS07

JGBC18, JGBS18 specifications

The GE JGBS18 and JGBC18 are modern gas ranges that combine functionality with advanced technology, catering to both professional chefs and home cooks. These models are designed to optimize cooking performance while enhancing user experience.

One of the standout features of the JGBS18 and JGBC18 is their powerful burners, including a high-output burner that delivers an impressive 15,000 BTUs. This allows for rapid heating and boiling, making it ideal for a variety of cooking techniques. The precision simmer burner is another highlight, providing low, even heat for delicate tasks such as melting chocolate or preparing sauces.

In terms of technology, GE integrates its TrueTemp system for consistent oven temperatures, ensuring that dishes cook evenly from all angles. The range features an easy-to-use electronic oven control that provides precise temperature settings and cooking modes, including bake, broil, and clean functions. The self-cleaning feature simplifies maintenance, using high temperatures to eliminate food residue, leaving the oven clean without the need for harsh chemicals.

The oven's interior is coated with a durable enamel finish that resists stains and provides easy cleanup. With a total oven capacity of 5.0 cubic feet, the JGBS18 and JGBC18 can accommodate multiple dishes, making it suitable for families or entertaining guests. The oven also includes a convenient interior oven light that lets users monitor cooking progress without opening the door, ensuring heat is retained.

Design-wise, both models boast sleek finishes that blend seamlessly into various kitchen decors. The heavy-duty cast iron grates provide a sturdy cooking surface and enhance the aesthetics of the range. The models come equipped with a standard broiler drawer, allowing for versatile cooking options, from broiling meats to toasting bread.

Safety features are paramount in the JGBS18 and JGBC18 designs, which include a gas safety shutoff system, preventing gas leaks and providing peace of mind. The ignition system is designed for reliable starting every time, ensuring that users can start cooking with confidence.

In summary, the GE JGBS18 and JGBC18 gas ranges offer a blend of powerful cooking capabilities, user-friendly technology, and thoughtful design details, making them ideal choices for those looking to elevate their culinary experience while maintaining ease of use and safety in the kitchen.
Top Page Image Contents