Care and Cleaning, Oven Light Replacement | GE 164D2966P238 instruction

GE 164D2966P238, 49-8726 Care and Cleaning, Oven Light Replacement, To remove, To replace cover

Page 31

CARE AND CLEANING

If your range is removed for cleaning, servicing or any reason, be sure anti-tip device is re-engaged properly when the range is replaced. Failure to take this precaution could result in tipping of the range and cause injury.

Proper care and cleaning are important so your radiant range will give you efficient and satisfactory service. If soil, mineral deposits from evaporated water spills or metal rub-off from aluminum cookware is not removed, it will burn on the glass cooktop surface and cause permanent discoloration.

Follow these directions carefully in caring for the radiant cooktop to help assure safe and proper maintenance.

Be sure that the surface unit control knobs are turned off and that the entire cooktop is cool before cleaning. (Sugar spills are the exception. Please see the Glass Cooktop Cleaning section.) Do not use a cooktop cleaner on a hot cooktop. The fumes can be hazardous to your health and can chemically attack the glass surface.

BE SURE ELECTRIC POWER IS OFF BEFORE CLEANING ANY PART OF THE RANGE.

Operating the Self-Cleaning

Oven Light Replacement

CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel. Be sure to let the light cover and bulb cool completely.

Wire cover holder

The oven light bulb is covered with a removable glass cover that is held in place with a bail-shaped wire. Remove the oven door, if desired, to reach cover easily.

To remove:

1.Hold a hand under the cover so it doesn’t fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover.

DO NOT REMOVE ANY SCREWS TO REMOVE COVER.

2.Do not touch hot bulb with a wet cloth. Replace bulb with a 40-watt household appliance bulb.

To replace cover:

1.Place it into groove of the light receptacle. Pull wire forward to the center of the cover until it snaps into place. When in place, the wire holds the cover firmly. Be certain the wire is in the depression in the center of the cover.

2.Connect electrical power to the range.

(continued next page)

Oven

Care and Cleaning

Image 31

Contents

UseandCare& Installation Guide Help US Help YOU… If YOU Need SERVICE…Read all instructions before using this appliance Important Safety InstructionsOven Self-Cleaning OvenCooktop and Radiant Surface Units Save These InstructionsJBP63 Features of Your RangeBroil Element Oven Door Latch Automatic Oven Light Switch Oven Interior LightExplained Storage Drawer Anti-Tip DeviceType of Cooktop Description How It Works Radiant HOW does this Cooktop Compare To Your OLD ONE?General Information About Radiant Surface Units Hot Surface Indicator LightSurface Controls How to Set the ControlsCooking Guide for Using Heat Settings Surface unit on indicator light will glowPorcelain/enamel Surface Cookware TipsTypes of Cookware Copper BottomSpecial Cautions for Glass Cooktops How to Check Pan PerformanceFlat-bottomed canners are required for glass cooktops Home Canning TipsObserve the Following Points in Canning Canning should be done on the cooktop onlyFor heavy, burned on soil Glass Cooktop CleaningGlass Cooktop Cleaning For normal, light soilQuestions and Answers Automatic Timers and ClockMinute Timer To Set the Minute TimerOven Shelves Using Your OvenBefore Using Your Oven Oven ControlsOven Light Shelf PositionsBaking How to Set Your Range for BakingType of Food Shelf Position Baking Guides Pan PlacementPreheating Baking PansDon’t Peek PiesCakes Aluminum FoilHow to Set Immediate Start and Automatic Stop How to Time BakeTimed Baking How to Set Delay Start and Automatic Stop To Adjust the Thermostat Adjust the Oven ThermostatUse of Aluminum Foil RoastingRoasting Guide Why is my roast crumbling when I try to carve it?Frozen Roasts Broiling Why are my meats not turning out as brown as they should?Should I salt the meat before broiling? Oven door should be open to the broil stop position Broiling GuideBefore a Clean Cycle Operating the SELF-CLEANING OvenNormal Cleaning Time 3 hours Quick Reminder To Stop a Clean Cycle How to Set the Oven for CleaningSelf My oven shelves do not slide easily. What is the matter? After a Clean CycleShould there be any odor during the cleaning? Why do I have ash left in my oven after cleaning?To replace cover Care and CleaningOven Light Replacement To removeInside of the door Do not clean the bake element or the broil elementLift-Off Oven Door Oven Heating ElementsBroiler Pan and Grid Painted Surfaces Control Panel and KnobsOven Vent Metal PartsBefore YOU Begin Installation InstructionsStep Step Wire Power Cord Installation Step Wire Conduit Installation Step Final Check Problem Possible Cause QUESTIONS? USE this Problem SolverProblem Solver SELF-CLEAN Problem SolverWe’ll Be There Warranty