Grate | Sealed Burner |
Safety
Burner cap
Burner head
Electrode
Burner base
CAUTION: Do not operate the burner without all burner parts in place.
Turn all controls OFF before removing the burner parts.
The burner grates, caps, and burner heads can be lifted off, making them easy to clean.
Electrode
When one burner is turned to LITE, all the burners spark. Do not attempt to disassemble or clean around any burner while another burner is on. An electric shock may result, which could cause you to knock over hot cookware.
Instructions Operating Instructions
After cleaning, make sure the nipple in the burner head is positioned toward the electrode. Rotate the burner head around the burner base until it is level and securely seated.
Burner Heads
NOTE: Before removing the burner heads and caps, remember their size and location. Replace them in the same location after cleaning.
The slits in the burner heads of your range must be kept clean at all times for an even, unhampered flame.
You should clean the surface burners routinely, especially after bad spillovers, which could clog these openings.
To remove
Before putting the burner head back, shake out excess water and then dry it thoroughly by setting it in a warm oven for 30 minutes.
Replace the burner heads and caps. Make sure that the heads and caps are replaced in the correct location. There are 2 large, one medium and one small head and cap.
Installation Instructions Troubleshooting
Burner Caps
Small
Lift off when cool. Wash burner caps in hot,
Medium soapy water and rinse with clean water. You may scour with a plastic scouring pad to
remove
Large
Dry them in a warm oven or with a cloth— don’t reassemble them wet. Replace the burner caps.
Make sure that caps are replaced on the correct size burner. There are 2 large, one medium and one small head and cap.
Tips Customer Service
33