GE 164D3333P034, 49-8780 manual Power Cord Strain Relief Installation

Page 41

3 Power Cord Strain Relief Installation

	Remove the lower rear range wiring cover to expose the connector block
a
	and bracket.
	Remove the knockout ring (13⁄8″) located on bracket directly below the
b
	connector. To remove the knockout, use a pair of pliers to bend the
	knockout ring away from the bracket and twist until ring is removed.

	Knockout ring in bracket.	Knockout ring removed.
	Assemble the strain relief in the hole. Insert the power cord through the
c
	strain relief and tighten. Allow enough slack to easily attach the cord
	terminals to the connector block. If tabs are present at the end of the winged
	strain relief, they can be removed for better fit.

	NOTE: Do not install the power cord without a strain relief.

	Connector box
				Ground
				strap


Wiring cover						Bracket
(shown removed)


	Strain relief		Power cord			Strain relief bracket
	Strain relief					(Provided with range cord. Not part of range.)
						(Provided with range cord. Not part of range.)

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

41

Image 41

Contents GE Answer Center Congratulations You Are Now Part of the GE Family Staple sales slip or cancelled check hereWrite the model and serial numbers here You can find them on a label behindGE & You Service Partnership Small amount of carbon monoxide during the cleaning cycle Fiberglass insulation in self-clean ovens gives off a veryAll ranges can tip and injury could result California Safe Drinking Water and Toxic EnforcementSafety Precautions Safety Information When Cooking PORK… Oven SELF-CLEANING Oven Surface Cooking Units Radiant Surface Units Troubleshooting Tips Customer ServiceREMEMBER… Wok Cooking Using the surface unitsHow to Set Do not use the surface as a cutting board About the radiant surface units… glass cooktops onlySelecting types of cookware. glass cooktops only Clock and Timer Features Using the oven controlsUsing the self-cleaning oven section Oven Control SettingsBefore you begin… Using the ovenHow to Set the Oven for Broiling Preheating and Pan PlacementAluminum Foil HI Broil. To change from HI Broil to LO BroilComments Broiling guideUsing the clock and timer How to Set an Immediate Start Automatic Stop Using the timed baking and roasting featuresMake sure the oven clock shows the correct time of day How to Set a Delay Start and Automatic StopTo Adjust the Thermostat Adjust the oven thermostat-Do it yourselfBefore a Clean Cycle Using the self-cleaning ovenPress the Auto Self Clean pad How to Set the Oven for CleaningAfter a Clean Cycle How to Delay the Start of CleaningControl Panel and Knobs Care and cleaning of the rangeOven Shelves Painted SurfacesSure Grip Handle To clean the outside of the door To clean the inside of the doorLift-Off Oven Door Do not lift the door by the handleOven Heating Elements Oven Light ReplacementTo remove the cover Do not remove any screws to remove the coverOperating Instructions Safety Information To replace a surface unit To remove a surface unitTo replace Cooktop Surface LightTo remove Broiler Pan & Grid How to Remove the Storage Drawer to Clean Under the RangeTo remove the storage drawer To replace the storage drawerDaily Cleaning Cleaning the glass cooktopFor heavy, burned-on soil National Parts CenterSpecial Care Wiring must conform to National Electric Codes Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeStrain relief, they can be removed for better fit Power Cord Strain Relief InstallationDo not remove ground strap connection Wire Power Cord InstallationBefore After Wire Conduit Installation Connector block terminal Bare wire Final Check Anti-Tip Bracket InstallationLeveling the Range Control signals after Before you call for service…Oven will not work Entering cook timeSee the Broiling guide Food does notBroil properly At Broil Broil HI/LO pad Clock and timer Oven temperatureFood does not bake Or roast properlySelf-clean cycle Self-cleanWhen you wanted Oven will notAfter a clean cycle Oven not cleanExcessive smoking Oven door willPower outage When you wantLock light is on To cookOff and on Frequent cyclingSurface units Surface units will not Maintain a rolling boilNot functioning Surface unitsProperly Cooktop feels hotFive Years Replacement glass cooktop if it should crack due GE Electric Range WarrantyWe Will Replace, At No Charge To You What GE Will Not CoverTDD 800-TDD-GEAC Service Telephone NumbersIn-Home Repair Service 800-GE-CARES