GE 164D3333P034, 49-8780 manual Special Care

Page 37

Using a razor scraper will not damage the surface if the 30° angle is maintained.

Special Care

Be sure to use a new sharp razor scraper. Do not use a dull or nicked blade.

Sugary spillovers (such as jellies, fudge, candy syrups) or melted plastics can cause pitting of the surface of your cooktop (not covered by the warranty) unless the spill is removed while still hot. Special care should be taken when removing hot substances.

	Turn off all surface units affected by the spillover.
1	Turn off all surface units affected by the spillover.
	Remove hot pans.
	Wearing an oven mitt, hold the razor scraper at a
2	Wearing an oven mitt, hold the razor scraper at a
	30° angle to the cooktop. Scrape the hot spill to a
	cool area outside the surface unit.
	With the spill in a cool area, use a dry paper towel to
3	With the spill in a cool area, use a dry paper towel to
	remove any excess. Any spillover remaining should

be left until the surface of the cooktop has cooled. Do not continue to use the soiled surface unit until all of the spillover has been removed. Follow the steps under Heavy soil to continue the cleaning process.

NOTE: If pots with a thin overlay of aluminum, copper or enamel are allowed to boil dry, the overlay may bond with the glass cooktop and leave a black discoloration. This should be removed immediately before heating again or the discoloration may be permanent.

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

37

Image 37

Contents GE Answer Center Congratulations You Are Now Part of the GE Family Staple sales slip or cancelled check hereWrite the model and serial numbers here You can find them on a label behindGE & You Service Partnership Small amount of carbon monoxide during the cleaning cycle Fiberglass insulation in self-clean ovens gives off a veryAll ranges can tip and injury could result California Safe Drinking Water and Toxic EnforcementSafety Precautions Safety Information When Cooking PORK… Oven SELF-CLEANING Oven Surface Cooking Units Radiant Surface Units Troubleshooting Tips Customer ServiceREMEMBER… How to Set Using the surface unitsWok Cooking Do not use the surface as a cutting board About the radiant surface units… glass cooktops onlySelecting types of cookware. glass cooktops only Clock and Timer Features Using the oven controlsUsing the self-cleaning oven section Oven Control SettingsBefore you begin… Using the ovenHow to Set the Oven for Broiling Preheating and Pan PlacementAluminum Foil HI Broil. To change from HI Broil to LO BroilComments Broiling guideUsing the clock and timer How to Set an Immediate Start Automatic Stop Using the timed baking and roasting featuresMake sure the oven clock shows the correct time of day How to Set a Delay Start and Automatic StopTo Adjust the Thermostat Adjust the oven thermostat-Do it yourselfBefore a Clean Cycle Using the self-cleaning ovenPress the Auto Self Clean pad How to Set the Oven for CleaningAfter a Clean Cycle How to Delay the Start of CleaningControl Panel and Knobs Care and cleaning of the rangeSure Grip Handle Painted SurfacesOven Shelves To clean the outside of the door To clean the inside of the doorLift-Off Oven Door Do not lift the door by the handleOven Heating Elements Oven Light ReplacementTo remove the cover Do not remove any screws to remove the coverOperating Instructions Safety Information To replace a surface unit To remove a surface unitTo remove Cooktop Surface LightTo replace Broiler Pan & Grid How to Remove the Storage Drawer to Clean Under the RangeTo remove the storage drawer To replace the storage drawerDaily Cleaning Cleaning the glass cooktopFor heavy, burned-on soil National Parts CenterSpecial Care Wiring must conform to National Electric Codes Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeStrain relief, they can be removed for better fit Power Cord Strain Relief InstallationDo not remove ground strap connection Wire Power Cord InstallationBefore After Wire Conduit Installation Connector block terminal Bare wire Leveling the Range Anti-Tip Bracket InstallationFinal Check Control signals after Before you call for service…Oven will not work Entering cook timeBroil properly At Broil Broil HI/LO pad Food does notSee the Broiling guide Clock and timer Oven temperatureFood does not bake Or roast properlySelf-clean cycle Self-cleanWhen you wanted Oven will notAfter a clean cycle Oven not cleanExcessive smoking Oven door willPower outage When you wantLock light is on To cookOff and on Frequent cyclingSurface units Surface units will not Maintain a rolling boilNot functioning Surface unitsProperly Cooktop feels hotFive Years Replacement glass cooktop if it should crack due GE Electric Range WarrantyWe Will Replace, At No Charge To You What GE Will Not CoverIn-Home Repair Service 800-GE-CARES Service Telephone NumbersTDD 800-TDD-GEAC