GE 49-8780, 164D3333P034 manual Anti-Tip Bracket Installation, Leveling the Range, Final Check

Page 46

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

8 Anti-Tip Bracket Installation

An Anti-Tip bracket is supplied with instructions for installation in a variety of locations. The instructions include a template, a parts list and a list of tools necessary to complete the installation. Read the Important Safety Information and the instructions that fit your situation before beginning installation.

WARNING

■Range must be secured by Anti-Tip bracket supplied.

■See instructions to install (supplied with bracket).

■Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury might result from spilled hot liquids or from the range itself.

Bracket

Wall plate

Screw must enter wood or metal

Typical installation of anti-tip bracket attachment to wall.

9 Leveling the Range

The range must be level. Leveling feet are located at each corner of the base of the range. Remove the storage drawer or kick panel (depending on your model) and using channel locks, rotate the leveling feet in and out as required to level the range. (For instructions on how to remove and replace the storage drawer or the kick panel, see the Care and cleaning of the range section.)

On some models, there are plastic covers which may be removed for easy adjustment (just squeeze and pull).

One of the rear leveling feet will engage the Anti-Tip bracket (allow for some side to side adjustment). Allow a minimum clearance of 1/8″ between the range and the leveling foot that is to be installed into the Anti-Tip bracket.

Check the range for proper installation into the Anti-Tip bracket by removing the kick panel or storage drawer and inspecting the rear leveling leg. Make sure it fits securely into the slot.

10 Final Check

Be sure all range controls are in the OFF position before leaving the range.

46

Image 46

Contents GE Answer Center Write the model and serial numbers here Staple sales slip or cancelled check hereCongratulations You Are Now Part of the GE Family You can find them on a label behindGE & You Service Partnership All ranges can tip and injury could result Fiberglass insulation in self-clean ovens gives off a verySmall amount of carbon monoxide during the cleaning cycle California Safe Drinking Water and Toxic EnforcementSafety Precautions Safety Information When Cooking PORK… Oven SELF-CLEANING Oven Surface Cooking Units Troubleshooting Tips Customer Service Radiant Surface UnitsREMEMBER… How to Set Using the surface unitsWok Cooking About the radiant surface units… glass cooktops only Do not use the surface as a cutting boardSelecting types of cookware. glass cooktops only Using the oven controls Clock and Timer FeaturesOven Control Settings Using the self-cleaning oven sectionUsing the oven Before you begin…Aluminum Foil Preheating and Pan PlacementHow to Set the Oven for Broiling HI Broil. To change from HI Broil to LO BroilBroiling guide CommentsUsing the clock and timer Using the timed baking and roasting features How to Set an Immediate Start Automatic StopHow to Set a Delay Start and Automatic Stop Make sure the oven clock shows the correct time of dayAdjust the oven thermostat-Do it yourself To Adjust the ThermostatUsing the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning Press the Auto Self Clean padHow to Delay the Start of Cleaning After a Clean CycleCare and cleaning of the range Control Panel and KnobsSure Grip Handle Painted SurfacesOven Shelves Lift-Off Oven Door To clean the inside of the doorTo clean the outside of the door Do not lift the door by the handleTo remove the cover Oven Light ReplacementOven Heating Elements Do not remove any screws to remove the coverOperating Instructions Safety Information To remove a surface unit To replace a surface unitTo remove Cooktop Surface LightTo replace To remove the storage drawer How to Remove the Storage Drawer to Clean Under the RangeBroiler Pan & Grid To replace the storage drawerFor heavy, burned-on soil Cleaning the glass cooktopDaily Cleaning National Parts CenterSpecial Care Installation of the range Wiring must conform to National Electric CodesPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Strain relief, they can be removed for better fitWire Power Cord Installation Do not remove ground strap connectionBefore After Wire Conduit Installation Connector block terminal Bare wire Leveling the Range Anti-Tip Bracket InstallationFinal Check Oven will not work Before you call for service…Control signals after Entering cook timeBroil properly At Broil Broil HI/LO pad Food does notSee the Broiling guide Food does not bake Oven temperatureClock and timer Or roast properlyWhen you wanted Self-cleanSelf-clean cycle Oven will notExcessive smoking Oven not cleanAfter a clean cycle Oven door willLock light is on When you wantPower outage To cookSurface units Surface units will not Frequent cyclingOff and on Maintain a rolling boilProperly Surface unitsNot functioning Cooktop feels hotWe Will Replace, At No Charge To You GE Electric Range WarrantyFive Years Replacement glass cooktop if it should crack due What GE Will Not CoverIn-Home Repair Service 800-GE-CARES Service Telephone NumbersTDD 800-TDD-GEAC