GE 49-8780, 164D3333P034 manual Wire Conduit Installation

Page 44

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

6 3-Wire Conduit Installation

Remove the 3 screws from the connector block. Insert bare wires between the connector block terminals and movable nuts. Tighten screws securely. Do not remove ground strap connection.

WARNING: Connector block is approved for copper wire connection only. If aluminum wire is used, see note below.

NOTE: ALUMINUM WIRING

a Do not connect aluminum wire to the connector block.

Use copper building wire rated for the correct amperage and voltage to make 3 (three) 3″ copper jumper wires. Connect wire as per Step 6 or 7 depending on number of wires.

b Splice copper wires to aluminum wiring using special connector terminals designed and UL-approved for joining copper to aluminum and follow the connector manufacturer’s recommended procedure closely.

Wire used, location and enclosure of splices, etc., must conform to good wiring practices and local codes.

Screw

 

Connector block

Bare wire tips

Connector block terminal

 

Bare wire

 

Movable nut

 

Flexible cable

 

Bracket

Conduit

 

44

Image 44
Contents GE Answer Center Staple sales slip or cancelled check here Congratulations You Are Now Part of the GE FamilyWrite the model and serial numbers here You can find them on a label behindGE & You Service Partnership Fiberglass insulation in self-clean ovens gives off a very Small amount of carbon monoxide during the cleaning cycleAll ranges can tip and injury could result California Safe Drinking Water and Toxic EnforcementSafety Precautions Safety Information When Cooking PORK… Oven SELF-CLEANING Oven Surface Cooking Units Troubleshooting Tips Customer Service Radiant Surface UnitsREMEMBER… Wok Cooking Using the surface unitsHow to Set About the radiant surface units… glass cooktops only Do not use the surface as a cutting boardSelecting types of cookware. glass cooktops only Using the oven controls Clock and Timer FeaturesOven Control Settings Using the self-cleaning oven sectionUsing the oven Before you begin…Preheating and Pan Placement How to Set the Oven for BroilingAluminum Foil HI Broil. To change from HI Broil to LO BroilBroiling guide CommentsUsing the clock and timer Using the timed baking and roasting features How to Set an Immediate Start Automatic StopHow to Set a Delay Start and Automatic Stop Make sure the oven clock shows the correct time of dayAdjust the oven thermostat-Do it yourself To Adjust the ThermostatUsing the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning Press the Auto Self Clean padHow to Delay the Start of Cleaning After a Clean CycleCare and cleaning of the range Control Panel and KnobsOven Shelves Painted SurfacesSure Grip Handle To clean the inside of the door To clean the outside of the doorLift-Off Oven Door Do not lift the door by the handleOven Light Replacement Oven Heating ElementsTo remove the cover Do not remove any screws to remove the coverOperating Instructions Safety Information To remove a surface unit To replace a surface unitTo replace Cooktop Surface LightTo remove How to Remove the Storage Drawer to Clean Under the Range Broiler Pan & GridTo remove the storage drawer To replace the storage drawerCleaning the glass cooktop Daily CleaningFor heavy, burned-on soil National Parts CenterSpecial Care Installation of the range Wiring must conform to National Electric CodesPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Strain relief, they can be removed for better fitWire Power Cord Installation Do not remove ground strap connectionBefore After Wire Conduit Installation Connector block terminal Bare wire Final Check Anti-Tip Bracket InstallationLeveling the Range Before you call for service… Control signals afterOven will not work Entering cook timeSee the Broiling guide Food does notBroil properly At Broil Broil HI/LO pad Oven temperature Clock and timerFood does not bake Or roast properlySelf-clean Self-clean cycleWhen you wanted Oven will notOven not clean After a clean cycleExcessive smoking Oven door willWhen you want Power outageLock light is on To cookFrequent cycling Off and onSurface units Surface units will not Maintain a rolling boilSurface units Not functioningProperly Cooktop feels hotGE Electric Range Warranty Five Years Replacement glass cooktop if it should crack dueWe Will Replace, At No Charge To You What GE Will Not CoverTDD 800-TDD-GEAC Service Telephone NumbersIn-Home Repair Service 800-GE-CARES