Amana ART6113*, ART6114* owner manual Care and Cleaning, Removing Oven Door Replacing Oven Light

Page 21

Care and Cleaning

Removing Oven Door

Replacing Oven Light

!CAUTION

To avoid personal injury or property damage, handle oven door with care.

Door is heavy and can be damaged if dropped.

Avoid placing hands in hinge area when door is removed. Hinge can snap closed and pinch hands.

Do not scratch or chip glass, or twist door. Glass may break suddenly.

Replace door glass if damaged.

Do not lift door by handle.

1.Open door fully.

2.Remove screws.

Oven doors are attached with a screw on each side of lower oven door.

3.Close door to first stop, grasp door firmly on each side, and lift upward until door is off hinges.

Do not lift door by handle. Glass can break.

Only push hinges closed once oven door is removed if necessary. Use both hands when closing hinge. Hinge snaps closed.

!WARNING

To avoid risk of burns or electrical shock, disconnect electrical supply to oven before changing light bulb.

Before replacing light bulb make sure bulb is cool.

Do not operate oven without bulb and cover in place.

!CAUTION

Wear gloves to protect hands from accidental bulb breakage.

1.Disconnect electrical supply.

2.Remove oven door if desired.

3.Unscrew light bulb cover located in rear of oven cavity. Then turn light bulb counterclockwise to remove.

4.Replace light bulb with 120-volt, 40-watt appliance bulb.

Do not overtighten bulb or it may be difficult to remove later.

5.Replace light bulb cover and oven door before use.

6.Reconnect power supply.

Removing Oven Door

Removing Storage Drawer (Some Models)

1.Slide drawer out until it stops.

2.Grasp drawer sides near back of drawer.

3.Lift up and out. Reverse to reinstall.

Replacing Oven Light Bulb

Removing Panel (Some Models)

1.Remove 2 screws at bottom of panel.

2.Push panel up so tabs on top of panel clear range frame.

3.Lift panel away from range.

• Reverse to reinstall.

Removing Storage Drawer

Removing Panel

21

Image 21
Contents Customer Please Read Manual Before Operating Range InstallerContents Important Safety Information Case of Fire PrecautionsSurface Element Fire Oven FiresPacking Material InstallationRange Location Cabinet OpeningPower Cord Requirements Power Supply LocationIrregular Cabinet and Countertop Heights Line Voltage RequirementsNeutral terminal connect wire Installing 3-Wire Power CordPower terminals Ground strapInstalling 4-Wire Power Cord Anti-tip Bracket Installation Converting 3-Wire to 4-Wire Power CordRemoval and Replacement of Range Level RangeOperation Range FeaturesSurface Element Settings Preparing to Cook with Smoothtop Elements Some ModelsCooking with Surface Elements Utensils Type Temperature UsesElectronic Oven Control Oven Signals DescriptionPads and Knobs Description Panel Lights DescriptionOther Features Oven Switches DescriptionSetting Electronic Clock Setting Electronic TimerPrepare to Bake Oven Rack Placement Bake Pan PlacementBaking Prepare for Self-clean Self-cleanBroiling Broiling TipsSelf-cleaning Interrupt Self-Clean CycleAfter Self-cleaning Cycle Cooking Guide Food Oven Temperature Cooking TimeBaking Guide Poultry Roasting GuideBeef and Pork Roasting Guide Broiling GuideFood Thickness Rack position Cooking time Removing Oven Door Replacing Oven Light Care and CleaningRemoving Storage Drawer Some Models Removing Panel Some ModelsPart Materials to Use General Directions CleaningProblem Cause To Prevent To Remove Cleaning Smoothtop RangetopProblem Check Before Calling for ServiceCooking Products excluding wall ovens WarrantyPage Page Quick Reference Instructions