Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later date.
Oven Door
CAUTION
•Do not place excessive weight on or stand on an open oven door. This could cause the range to tip over, break the door, or injure the user.
•Do not attempt to open or close door or operate oven until door is properly replaced.
•Never place fingers between hinge and front oven frame. Hinge arms are spring mounted. If accidentally hit, the hinge will slam shut against oven frame and could injure your fingers.
Important: The oven door on a new range may feel “spongy” when it is closed. This is normal and will decrease with use.
To remove:
1. When cool, open the oven door to the first stop position (opened about four inches).
2. Grasp door at each side. Do not use the door handle to lift door.
3. Lift up evenly until door clears hinge arms.
To replace:
1.Grasp door at each side.
2.Align slots in the door with the hinge arms on the range.
3.Slide the door down onto the hinge arms until the door is completely seated on the hinges. Push down on the top corners of the door to completely seat door on hinges. Door should not appear crooked.
Leveling Legs
CAUTION
Be sure the
Be sure the range is leveled when installed. If the range is not level, turn the leveling legs, located at each corner of the range, until range is level.
Oven Light
CAUTION
•Disconnect power to range before replacing light bulb.
•Use a dry potholder to prevent possible harm to hands when replacing bulb.
•Be sure bulb is cool before touching bulb.
•Do not touch hot bulb with a damp cloth as this may cause the bulb to break.
To replace oven light bulb:
1.When oven is cool, hold bulb cover in place, then slide wire retainer off cover. Important: Bulb cover will fall if not held
in place while removing wire retainer.
2. Remove bulb cover and light bulb.
3. Replace with a
appliance bulb.WIRE
RETAINER
4.Replace bulb cover and secure with wire retainer.
5.Reconnect power to range. Reset clock.
Storage Drawer
CAUTION
Do not store plastic, paper products, food or flammable materials in this drawer. The drawer may become too warm for these items when the oven is in use.
The storage drawer can be removed to allow you to clean under the range.
To remove:
1.Empty drawer and pull out to the first stop position.
2.Lift up the front of the drawer.
3.Pull out to the second stop position.
4.Grasp sides and lift drawer up and out.
To replace:
1.Fit the ends of the drawer glides into the rails in the range.
2.Lift up the front of the drawer and gently push in to the first stop position.
3.Lift drawer up again and push until drawer is closed.
BRACKET
LEVELING LEG
8