Amana 8113P550-60 manual Favorite, Changing Temp F/C, Keep Warm Notes

Page 12

Oven Cooking

Keep Warm

For safely keeping foods warm or for warming breads and plates.

To set Keep Warm:

1. Press the Keep Warm pad.

WARM flashes.

000 appears in the display.

2. Select the Keep Warm temperature. The Keep Warm temperature can be set from 145° to 190°. Press or press and hold the ▲ or ▼ pad.

170° will light when either pad is first pressed.

Press the ▲ pad to increase the temperature.

Press the ▼ pad to decrease the temperature.

WARM and the temperature will be displayed while Keep Warm is active.

To cancel Keep Warm:

1. Press the Cancel pad.

2. Remove food from the oven.

Keep Warm Notes:

For optimal food quality, oven cooked foods should be kept warm for no longer than 1 to 2 hours.

To keep foods from drying, cover loosely with foil or a lid.

To warm dinner rolls:

-cover rolls loosely with foil and place in oven.

-press Keep Warm and ▲ pads to set 170° F.

-warm for 12-15 minutes.

To warm plates:

-place 2 stacks of up to four plates each in the oven.

-press Keep Warm and ▲ pads to set 170° F.

-warm for five minutes, turn off the oven and leave plates in the oven for 15 minutes more.

-use only oven-safe plates, check with the manufacturer.

-do not set warm dishes on a cold surface as rapid temperature changes could cause crazing.

Favorite

The Favorite pad allows you to save the time and temperature from a Cook & Hold function.

To set a Favorite cycle, Cook & Hold must be either active or just programmed.

To set a new Favorite cycle or to save a currently running Cook & Hold as a Favorite:

1.Program a Cook & Hold cycle as described in the Cook & Hold section on page 9.

2. Press and hold the Favorite pad for three seconds.

The newly set or currently running Cook & Hold cycle will be saved.

A beep will sound to indicate that the control has accepted the Favorite setting.

To start a cycle programmed into Favorite:

1. Press the Favorite pad.

• Time and temperature for the set Cook & Hold cycle will be displayed. (If no Cook & Hold cycle has been programmed, “nonE” is displayed.)

2.Press the Bake pad.

The Favorite cycle will begin immediately.

BAKE will light in the display

The cooking time will light in the display

When the cooking time has elapsed:

BAKE will turn off.

HOLD and WARM will light.

170° will display.

To cancel a Favorite cycle in progress:

1.Press the Cancel pad.

The stored Favorite cycle will not be affected.

2.Remove food from the oven.

Changing Temp °F/°C

1.The factory default setting for temperature is Fahrenheit.

2.To change the setting, press and hold the Cancel and Bake pads at the same time for three seconds.

3.A single beep will sound and the current setting will be displayed (°F or °C). (If no change is made, the range will return to the existing setting after 30 seconds.)

4.To change the setting, press the ▲ or ▼ pad. Press again to return to existing setting. Wait five seconds and the setting will be complete.

11

Image 12
Contents Care & Cleaning 16-18 Maintenance 19-20Troubleshooting 21-22 Warranty & Service Electric Slide-In Smoothtop Easy Touch ControlRecognize Safety Symbols, Words, Labels InstructionsTo Prevent Fire or Smoke Damage Case of FireImportant Safety Instructions Child SafetyCooking Safety Utensil SafetySelf-Clean Oven Important Safety Notice and WarningCleaning Safety CooktopSetting the Controls Suggested Heat SettingsSurface Controls After cooking, turn knob to OFF. Remove panSmoothtop Surface Tips to Protect Smoothtop SurfaceCookware Recommendations Canning and Oversize CookwareTo Prevent Other Damage Flat Pan TestsUsing the Touchpads Oven CookingControl Panel ClockTimer Fault CodesLocking the Control Baking Cook & HoldBaking Differences Between Your Old and New Oven Baking NotesDelay Cook & Hold Keep Warm FavoriteChanging Temp F/C Keep Warm NotesBroiling Chart BroilingBroil Notes Rack Total Foods PositionAutomatic Shut-Off/Sabbath Mode Adjusting the Oven TemperatureSabbath Mode Notes Oven Fan Oven VentOven Light Oven BottomBefore Self-Cleaning To set Self-CleanTo Delay a Self-Clean Cycle During the Self-Clean Cycle After Self-CleaningCare & Cleaning Cleaning ProceduresPart Procedure First GlassMovement, then wipe off excess oil Stainless SteelMaintenance Oven DoorOven Window Oven Light style varies by modelLeveling Legs Storage DrawerTroubleshooting Problem SolutionTo the self-clean cycle Word is not displayedOff. This is normal Continue to run after use until the oven coolsWarranty & Service WarrantyWhat is Not Covered By These Warranties If You Need Service25-28 29-3132-40 41-44Pour éviter un incendie ou des dommages par la fumée Les instructions de sécurité importantes et les paragraphesEn cas d’incendie Sécurité pour les enfantsFamiliarisation avec l’appareil Cuisson et sécuritéUstensiles et sécurité Table de cuissonFriteuses Hottes d’extractionFour autonettoyant Avertissement et avis important pour la sécuritéConserver ces instructions pour consultation ultérieure Nettoyer uniquement les pièces mentionnées dans ce guideBoutons de commande Réglage des commandesCuisson sur la surface Suggestions de réglageSurface à dessus lisse Conseils de protection de la surface à dessus lisseRecommandations sur les ustensiles Ustensiles de grande taille et pour les conservesPour éviter d’autres dommages Tests pour vérifier si les ustensiles ont un fond platTableau de commande Cuisson dans le fourUtilisation des touches HorlogeVerrouillage des commandes MinuterieCodes d’anomalie Cuisson courante Cuisson et maintienRemarques sur la cuisson courante au four Différences de cuisson entre l’ancien four et le nouveauCuisson et maintien différée Maintien au chaud Remarques sur la fonction maintien au chaudProgrammation du maintien au chaud Annulation du maintien au chaudCuisson au gril Remarques sur la cuisson au grilTableau de cuisson au gril Position Degré DE Temps DE Cuisson AlimentsArrêt automatique Mode sabbat Remarques sur le mode sabbatAnnulation du mode sabbat Programmer le four pour une cuisson courante voirAjustement de la température du four Changement de la température F/CFavori Ventilateur du four Évent du fourÉclairage du four Sole du fourNettoyage Avant l’autonettoyageProgrammation de l’autonettoyage Démarrage différé d’un cycle d’autonettoyageAprès le cycle d’autonettoyage Pendant le cycle d’autonettoyageRemarques Méthodes de nettoyage Pièce NettoyageVaporisant d’abord sur un linge ’excédentPorte Entretien Porte du fourLampe du four Hublot du fourPieds de réglage de l’aplomb Tiroir de remisageDépose Problème Solution Recherche des pannesLes commandes et la porte sont peut-être verrouillées. Voir Nettoyage recommandés. VoirLa porte du four ne se déverrouille Pas après l’autonettoyageGarantie et service après-vente Garantie Ne sont pas couverts par ces garantiesSi vous avez besoin d’aide Instrucciones Importantes 51-5455-57 58-66Para Evitar un Incendio o Daño Causado por el Humo Fecha de CompraCanadá En Caso de Incendio Seguridad para los NiñosInstrucciones Generales Seguridad al CocinarCubierta Seguridad sobre el Uso de UtensiliosOllas Freidoras Campanas de VentilaciónSeguridad en la Limpieza Horno AutolimpianteAviso y Advertencia Importante Sobre Seguridad Conserve estas Instrucciones para Referencia FuturaCocinando en la Estufa Controles SuperioresProgramación de los Controles Ajustes de calor sugeridosCubiertas Lisas Consejos para proteger la cubierta lisaRecomendaciones sobre los utensilios Utensilios para preparar conservas y de tamaños grandesPara evitar otros daños Prueba de las Ollas PlanasCocinando en el Horno Panel de ControlUso de las Teclas ‘Clock’ RelojCódigos de Errores ‘Timer’ TemporizadorBloqueo de los Controles ‘Cook & Hold’ Cocción y ‘Bake’ HorneadoNotas sobre Horneado Mantener Caliente‘Delay Cook & Hold’ Cocción y Para cancelarMantener Caliente Diferido Después de una hora en ‘HOLD WARM’ Mantener CalientePara cancelar ‘Keep Warm’ ‘Keep Warm’ Mantener CalienteNotas sobre ‘Keep Warm’ Para programar ‘Keep Warm’‘Broiling’ Asar a la Parrilla Notas Sobre Asado a la ParrillaTabla de Asar a la Parrilla Posicion DE Termino DE Tiempo Total DE AlimentosPara cancelar ‘Bake’ cuando el Modo Sabático está activo Para cancelar el Modo SabáticoCierre Automático Modo Sabático Notas Sobre el Modo SabáticoAjuste de la temperatura del horno ‘Favorite’ FavoritoCambio de la temperatura de F/C Ventilador del horno Respiradero del HornoPanel Inferior del Horno Posiciones de la ParrillaPara programar ‘Self-Clean’ Autolimpieza Antes de la AutolimpiezaPara diferir un ciclo de autolimpieza Limpie el marco del horno, el marco deDespués del ciclo de autolimpieza Durante el ciclo de autolimpiezaNotas Procedimientos de Limpieza Pieza Procedimiento DE LimpiezaCuidado y Limpieza Mantenimiento Puerta del HornoLuz del Horno Ventana del HornoTornillos Niveladores Gaveta de AlmacenamientoProblema Solución Localización y Solución de AveríasCódigos de Errores Marcas de metalCrema para Limpieza de Cubiertas. Ver pág Manchas y estrías marronesGarantía y Servicio GarantíaLo que no cubren estas garantías Si necesita servicio

8113P550-60 specifications

The Amana 8113P550-60 is a high-performance gas furnace that exemplifies advanced engineering and energy efficiency for residential heating. With its robust design and cutting-edge technologies, it has become a popular choice for homeowners seeking reliability and comfort in colder climates.

One of the standout features of the Amana 8113P550-60 is its variable-speed blower motor. This innovative technology enhances the system's efficiency and maintains consistent temperature levels throughout the home. By adjusting the speed based on the heating demand, the blower motor not only optimizes comfort but also minimizes energy consumption, making it an environmentally-friendly choice.

Additionally, this furnace is equipped with a multi-position design, allowing for flexible installation options. Whether the furnace needs to be located in the attic, crawl space, or a closet, the Amana 8113P550-60 can adapt to various spaces, ensuring that homeowners have greater versatility during installation.

The furnace boasts a high AFUE (Annual Fuel Utilization Efficiency) rating, indicating that a significant portion of fuel is converted into usable heat. This efficiency translates to lower utility bills and a smaller carbon footprint, aligning with the growing trend of eco-conscious consumer choices.

Another highlight of the Amana 8113P550-60 is its reliaable two-stage heating system. This feature allows the furnace to operate at lower capacity during milder temperatures, reducing energy usage while still keeping the home warm. On colder days, it can ramp up to provide additional heat, ensuring consistent comfort regardless of weather conditions.

In terms of safety and durability, the Amana 8113P550-60 is designed with a durable heat exchanger made from high-quality materials, enhancing its lifespan and reliability. It also includes a robust warranty, further emphasizing the manufacturer's commitment to quality and customer satisfaction.

Finally, the inclusion of advanced control systems allows homeowners to monitor and adjust settings conveniently. This adaptability provides an additional layer of energy savings, as users can establish heating schedules and respond to changing needs.

In summary, the Amana 8113P550-60 gas furnace combines impressive efficiency with innovative technologies, ensuring a reliable heating solution while keeping costs manageable and comfort high. Its variable-speed blower, flexible installation options, and two-stage heating system make it an excellent investment for any homeowner looking to enhance their indoor climate.