Amana 8113P550-60 manual Oven Fan, Oven Vent, Oven Light, Oven Bottom, Oven Racks, Rack Positions

Page 15

Oven Cooking

Oven Fan

A cooling fan will automatically turn on during all broiling and some baking operations. It is used to keep internal parts on the control panel cool. The fan will automatically turn off when parts have cooled. The fan may continue to operate after the oven has been turned off. This is normal.

Oven Vent

When the oven is in use the area near the vent may become hot enough to cause burns. Never block the vent opening.

The oven vent is located at the rear of the cooking surface.

OVEN VENT LOCATION

Do not place plastics near the vent opening as heat from the vent could distort or melt the plastic.

Oven Light

Press the Oven Light switch on the control panel to turn the oven light on and off. The oven light is only activated by this switch.

Oven Bottom

Protect oven bottom against spillovers, especially acidic or sugary spills, as they may discolor the porcelain enamel. Use the correct pan size to avoid spillovers and boilovers. Do not place utensils or aluminum foil directly on the oven bottom.

Oven Racks

CAUTION

•Do not attempt to change the rack position when the oven is hot.

•Do not use the oven for storing food or cookware.

The oven has two racks. All racks are designed with a lock-stop edge.

To remove:

1. Pull rack straight out until it stops at the lock-stop position.

2. Lift up on the front of the rack and pull out.

To replace:

1.Place rack on the rack supports in the oven.

2.Tilt the front end up slightly. Slide rack back until it clears the lock-stop position.

3.Lower front and slide back into the oven.

Never cover an entire rack with aluminum foil or place foil on the oven bottom. Baking results will be affected and damage may occur to the oven bottom.

Rack Positions

RACK 5: Used for toasting bread or broiling thin, non- fatty foods.

RACK 4: Used for most broiling.

RACK 3: Used for most baked goods on a cookie

sheet or jelly roll pan, layer

cakes, or frozen convenience foods and general single-rack baking.

RACK 2: Used for pound cakes, Bundt cakes, pies, casseroles and roasting small cuts of meat.

RACK 1: Used for pound cakes, 9 x 13 cakes, pies and roasting large cuts of meat and poultry.

MULTIPLE RACK COOKING:

Two rack: Use rack positions 2 and 5, or 1 and 4.

Note: Never place pans directly on the oven bottom.

Baking Layer Cakes on Two Racks

For best results when baking cakes on two racks, use racks 2 and 5.

Place the cakes on the rack as shown.

14

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Electric Slide-In Smoothtop Easy Touch Control Care & Cleaning 16-18Maintenance 19-20 Troubleshooting 21-22 Warranty & ServiceCase of Fire Recognize Safety Symbols, Words, LabelsInstructions To Prevent Fire or Smoke DamageUtensil Safety Important Safety InstructionsChild Safety Cooking SafetyCooktop Self-Clean OvenImportant Safety Notice and Warning Cleaning SafetyAfter cooking, turn knob to OFF. Remove pan Setting the ControlsSuggested Heat Settings Surface ControlsTips to Protect Smoothtop Surface Smoothtop SurfaceFlat Pan Tests Cookware RecommendationsCanning and Oversize Cookware To Prevent Other DamageClock Using the TouchpadsOven Cooking Control PanelTimer Fault CodesLocking the Control Baking Notes BakingCook & Hold Baking Differences Between Your Old and New OvenDelay Cook & Hold Keep Warm Notes Keep WarmFavorite Changing Temp F/CRack Total Foods Position Broiling ChartBroiling Broil NotesAutomatic Shut-Off/Sabbath Mode Adjusting the Oven TemperatureSabbath Mode Notes Oven Bottom Oven FanOven Vent Oven LightBefore Self-Cleaning To set Self-CleanTo Delay a Self-Clean Cycle After Self-Cleaning During the Self-Clean CycleCare & Cleaning Cleaning ProceduresPart Procedure Stainless Steel FirstGlass Movement, then wipe off excess oilOven Light style varies by model MaintenanceOven Door Oven WindowStorage Drawer Leveling LegsWord is not displayed TroubleshootingProblem Solution To the self-clean cycleContinue to run after use until the oven cools Off. This is normalIf You Need Service Warranty & ServiceWarranty What is Not Covered By These Warranties41-44 25-2829-31 32-40Les instructions de sécurité importantes et les paragraphes Pour éviter un incendie ou des dommages par la fuméeCuisson et sécurité En cas d’incendieSécurité pour les enfants Familiarisation avec l’appareilHottes d’extraction Ustensiles et sécuritéTable de cuisson FriteusesNettoyer uniquement les pièces mentionnées dans ce guide Four autonettoyantAvertissement et avis important pour la sécurité Conserver ces instructions pour consultation ultérieureSuggestions de réglage Boutons de commandeRéglage des commandes Cuisson sur la surfaceConseils de protection de la surface à dessus lisse Surface à dessus lisseTests pour vérifier si les ustensiles ont un fond plat Recommandations sur les ustensilesUstensiles de grande taille et pour les conserves Pour éviter d’autres dommagesHorloge Tableau de commandeCuisson dans le four Utilisation des touchesVerrouillage des commandes MinuterieCodes d’anomalie Différences de cuisson entre l’ancien four et le nouveau Cuisson couranteCuisson et maintien Remarques sur la cuisson courante au fourCuisson et maintien différée Annulation du maintien au chaud Maintien au chaudRemarques sur la fonction maintien au chaud Programmation du maintien au chaudPosition Degré DE Temps DE Cuisson Aliments Cuisson au grilRemarques sur la cuisson au gril Tableau de cuisson au grilProgrammer le four pour une cuisson courante voir Arrêt automatique Mode sabbatRemarques sur le mode sabbat Annulation du mode sabbatAjustement de la température du four Changement de la température F/CFavori Sole du four Ventilateur du fourÉvent du four Éclairage du fourDémarrage différé d’un cycle d’autonettoyage NettoyageAvant l’autonettoyage Programmation de l’autonettoyageAprès le cycle d’autonettoyage Pendant le cycle d’autonettoyageRemarques Pièce Nettoyage Méthodes de nettoyageVaporisant d’abord sur un linge ’excédentPorte Hublot du four EntretienPorte du four Lampe du fourPieds de réglage de l’aplomb Tiroir de remisageDépose Recherche des pannes Problème SolutionPas après l’autonettoyage Les commandes et la porte sont peut-être verrouillées. VoirNettoyage recommandés. Voir La porte du four ne se déverrouilleGarantie et service après-vente Garantie Ne sont pas couverts par ces garantiesSi vous avez besoin d’aide 58-66 Instrucciones Importantes51-54 55-57Para Evitar un Incendio o Daño Causado por el Humo Fecha de CompraCanadá Seguridad al Cocinar En Caso de IncendioSeguridad para los Niños Instrucciones GeneralesCampanas de Ventilación CubiertaSeguridad sobre el Uso de Utensilios Ollas FreidorasConserve estas Instrucciones para Referencia Futura Seguridad en la LimpiezaHorno Autolimpiante Aviso y Advertencia Importante Sobre SeguridadAjustes de calor sugeridos Cocinando en la EstufaControles Superiores Programación de los ControlesConsejos para proteger la cubierta lisa Cubiertas LisasPrueba de las Ollas Planas Recomendaciones sobre los utensiliosUtensilios para preparar conservas y de tamaños grandes Para evitar otros daños‘Clock’ Reloj Cocinando en el HornoPanel de Control Uso de las TeclasCódigos de Errores ‘Timer’ TemporizadorBloqueo de los Controles Mantener Caliente ‘Cook & Hold’ Cocción y‘Bake’ Horneado Notas sobre HorneadoDespués de una hora en ‘HOLD WARM’ Mantener Caliente ‘Delay Cook & Hold’ Cocción yPara cancelar Mantener Caliente DiferidoPara programar ‘Keep Warm’ Para cancelar ‘Keep Warm’‘Keep Warm’ Mantener Caliente Notas sobre ‘Keep Warm’Posicion DE Termino DE Tiempo Total DE Alimentos ‘Broiling’ Asar a la ParrillaNotas Sobre Asado a la Parrilla Tabla de Asar a la ParrillaNotas Sobre el Modo Sabático Para cancelar ‘Bake’ cuando el Modo Sabático está activoPara cancelar el Modo Sabático Cierre Automático Modo SabáticoAjuste de la temperatura del horno ‘Favorite’ FavoritoCambio de la temperatura de F/C Posiciones de la Parrilla Ventilador del hornoRespiradero del Horno Panel Inferior del HornoLimpie el marco del horno, el marco de Para programar ‘Self-Clean’ AutolimpiezaAntes de la Autolimpieza Para diferir un ciclo de autolimpiezaDespués del ciclo de autolimpieza Durante el ciclo de autolimpiezaNotas Pieza Procedimiento DE Limpieza Procedimientos de LimpiezaCuidado y Limpieza Ventana del Horno MantenimientoPuerta del Horno Luz del HornoGaveta de Almacenamiento Tornillos NiveladoresLocalización y Solución de Averías Problema SoluciónManchas y estrías marrones Códigos de ErroresMarcas de metal Crema para Limpieza de Cubiertas. Ver págSi necesita servicio Garantía y ServicioGarantía Lo que no cubren estas garantías

8113P550-60 specifications

The Amana 8113P550-60 is a high-performance gas furnace that exemplifies advanced engineering and energy efficiency for residential heating. With its robust design and cutting-edge technologies, it has become a popular choice for homeowners seeking reliability and comfort in colder climates.

One of the standout features of the Amana 8113P550-60 is its variable-speed blower motor. This innovative technology enhances the system's efficiency and maintains consistent temperature levels throughout the home. By adjusting the speed based on the heating demand, the blower motor not only optimizes comfort but also minimizes energy consumption, making it an environmentally-friendly choice.

Additionally, this furnace is equipped with a multi-position design, allowing for flexible installation options. Whether the furnace needs to be located in the attic, crawl space, or a closet, the Amana 8113P550-60 can adapt to various spaces, ensuring that homeowners have greater versatility during installation.

The furnace boasts a high AFUE (Annual Fuel Utilization Efficiency) rating, indicating that a significant portion of fuel is converted into usable heat. This efficiency translates to lower utility bills and a smaller carbon footprint, aligning with the growing trend of eco-conscious consumer choices.

Another highlight of the Amana 8113P550-60 is its reliaable two-stage heating system. This feature allows the furnace to operate at lower capacity during milder temperatures, reducing energy usage while still keeping the home warm. On colder days, it can ramp up to provide additional heat, ensuring consistent comfort regardless of weather conditions.

In terms of safety and durability, the Amana 8113P550-60 is designed with a durable heat exchanger made from high-quality materials, enhancing its lifespan and reliability. It also includes a robust warranty, further emphasizing the manufacturer's commitment to quality and customer satisfaction.

Finally, the inclusion of advanced control systems allows homeowners to monitor and adjust settings conveniently. This adaptability provides an additional layer of energy savings, as users can establish heating schedules and respond to changing needs.

In summary, the Amana 8113P550-60 gas furnace combines impressive efficiency with innovative technologies, ensuring a reliable heating solution while keeping costs manageable and comfort high. Its variable-speed blower, flexible installation options, and two-stage heating system make it an excellent investment for any homeowner looking to enhance their indoor climate.
Top Page Image Contents