Korg HDR-TRI manual Compare function, Track setting, select AT3&4

Page 14

Recording

Recording a guitar in stereo on tracks 3 and 4 while listening to audio tracks 1 and 2

1Use the procedure of “Recording an audio track” to record onto audio tracks 1 and 2.

2Connect your guitar to a stereo-output effect device.

3Connect the stereo-output effect device to the ANALOG IN 1 and 2 jacks.

Checking the external input

4In the Track setting, select AT3&4.

The input to the ANALOG IN 1 jack will be recorded onto audio track 3, and the input to the ANALOG IN 2 jack will be recorded onto audio track 4.

4

5

6 7

5In the Input Select setting, select Analog.

6In the Input Level setting, select –30 dBu.

7Play your guitar, and adjust the Rec Level so that the level meter does not rise all the way.

If the Input Level indicates Overload, the input level is too great. If this occurs, select the next higher setting for Input Level.

8Press the [RESET] key to return to the beginning of the song. Press the [REC/WRITE] key and then (after making sure that the [START/STOP] key LED is blinking) press the [START/STOP] key.

Recording will begin. While listening to audio tracks 1 and 2, play your guitar and record it on audio tracks 3 and 4.

9To stop recording, press the [START/STOP] key.

The Compare function

If you press the [COMPARE] key, the TRINITY will return to the state it was in before recording began (this is referred to as the Compare function). Press the [COMPARE] key once again, and the recorded data will reappear.

Introduction

Operation

Parameters

Appendix

11

Image 14

Contents HDR-TRI Table of Contents Table of Contents Features of the HDR-TRI About hard disk recordingAbout hard disks About sound and audio eventsTurn the power OFF for the Trinity and the hard disks Settings for recordingHard disk connections and settings On the hard disk, set an ID number in the rangeFormatting a hard disk Specify the size 0-540 Mbyte of the ﬁler partitionPress the OK button to execute formatting Connections for recording OutputinputSong settings Track ﬁeld, select the audio tracks that you wish to recordChecking the external input Example of connected device Press the REC/WRITE key RecordingRecording an audio track Press the START/STOP keyTo stop recording, press the START/STOP key Track setting, select AT3&4Compare function Playing back the tracks you recorded Adjusting the pan or volume balance of the tracksPlayback Recording mixer events Re-recording Using the rehearsal functionUsing auto punch-in recording to edit Track bouncing ping-pong recording EditingCreating repetitions of the same phrase Applying master effects Access the P8 tab 1 page Master FXBouncing Midi tracks and audio tracks together Set Pan to R127 for audio tracksCreating a song in conjunction with the Midi sequencer Creating a song in conjunction with the Midi sequencerWhen you ﬁnish recording, press the START/STOP key Access the Sequencer mode P1 tab 5 page MixA1-4Loading data from a hard disk Saving/loading recorded dataSaving song data to a hard disk Using the same sound more than once Using a recorded sound more than once in the same .SNG ﬁleCreating different arrangements using the same vocal Execute the page menu command Load SelectedAudio Track Rec 5c Tempo/Tempo ModeTempo Mode Menu5e Meter/Metronome/Resolution/Multi Rec/Remove Data Multi Rec5h Rehearsal 5f Take5g Take Number 5i Input Select Analog, Digital+4 dBu, -10 dBu, -30 dBu 5j Input Level5l Audio Track Name Display ∞ ...+18 dB5D Rec HD Select 5m Monitor Mode SelectMenu Command 6g Send1/Send2 127 Mix Audio Track6f EQ Equalizer 6h Pan PanpotWhen Solo is selected for one audio track 6i Volume 100...1276j Mix Audio Track Mode MANUAL/READ/MUTE/SOLO/WRITE When Solo is selected for two or more audio tracks6E Volume Pairing 6D Rec HD Select7h Recording Setup Preference5c Delay Samples/0...5 ms Audio Track parameter Audio TrackStart Measure 999 Audio Track Edit3i Start Measure/End Measure End Measure 9993B Automation Edit Copy button Insert buttonDelete button Audition Start/Stop button3E Erase Measure 3C Erase Audio Track3D Copy Audio Track Introduction Operation Parameters 3F Delete Measure3G Insert Measure 3H Copy Measure 3I Move Measure Trimming an audio event 3J Audio Event EditTrim button Location/Sound name Audition buttonsAudio Track Audition ParametersTrim Parameters Executing the trim operationDeleting an audio event Inserting an audio eventMoving an audio event Copying an audio eventStart/stop audition Audio Track Name 4j Audio Track Name4H Copy Measure 4F Delete Measure4G Insert Measure 4I Move MeasureLoad 1B Load Selected3C Copy Utility3B Rename 3G Format 3H WipeIntroduction Operation Parameters Appendix 4B Backup to DAT Audio Utility4C Restore from DAT 4D Copy with Sound 4E Disp Used Sound List4F Delete Unused Sound Disk P1 Appendix Memory full. Audio track can’t play to the end Error in wiping mediumDisk not formatted No unused sounds foundSpeciﬁcations Godzilla Wants my Trinity